The carbon you see in my filter is not sludge, instead it's likely carbon being cleaned from the pistons and ring lands.Here is my Durango pentastar after 5k miles.
No sludge.
I'd highly recommend changing your intervals.
The carbon you see in my filter is not sludge, instead it's likely carbon being cleaned from the pistons and ring lands.
Why would you recommend I change my OCIs?
Sludge requires moisture, without moisture, it forms varnish/lacquer, that's the definition of sludge, per this flow chart:That is oil sludge. Seen it a hundred times. If it was carbon from ringlands it would be miniscule. You'd not even see it in one change.
There is absolutely no question that's sludge. It's congealed oil ...the definition of sludge.
No, he doesn't.You have 16k mile changes.
You have visible sludge.
I'm very curious to read your professional interpretation of his UOA's. Would you mind crafting a detailed post on the matter, breaking down each observed trend that's concerning to you?You have UOA that confirms very high wear metals.
Hold onto your panties, but I got the same thing in my filters with Mobil 1 0W-40.Any "cleaner" that was doing enough to put congealed oil in the filter would be one that you remove immediately after running in the engine at idle or a prescribed rpm.
Any cleaner that did this would also be expressly prohibited by the manual and warranty.
It's the result of AN's and esters, which are very effective cleaners. This is the filter from my wife's truck, it had spent its entire life on Mobil 1 EP 0W-20 changed per the OLM, which, unlike the FS 0W-40, was not advertised to provide any cleaning capability. The HEMI is a very dirty running engine and AMSOIL has a TSB about them plugging their EaO filters, so they are not supposed to run extended intervals.Nobody would make an oil that sludges your oil and filter for thousands of miles.
Sludge requires moisture, without moisture, it forms varnish/lacquer, that's the definition of sludge, per this flow chart:
View attachment 156184
No, he doesn't.
I'm very curious to read your professional interpretation of his UOA's. Would you mind crafting a detailed post on the matter, breaking down each observed trend that's concerning to you?
Hold onto your panties, but I got the same thing in my filters with Mobil 1 0W-40.
This was from a BMW that was pretty ugly under the valve cover, M1 0W-40:
View attachment 156186
This was from our Expedition, which had no sludge and only very light varnish, engine had been run on dealer bulk 5W-20. Running M1 0W-40 yielded:
View attachment 156187
View attachment 156189
It's the result of AN's and esters, which are very effective cleaners. This is the filter from my wife's truck, it had spent its entire life on Mobil 1 EP 0W-20 changed per the OLM, which, unlike the FS 0W-40, was not advertised to provide any cleaning capability. The HEMI is a very dirty running engine and AMSOIL has a TSB about them plugging their EaO filters, so they are not supposed to run extended intervals.
View attachment 156190
The AN's and esters clean, the DI package makes sure this stuff doesn't agglomerate, staying in suspension, and makes its way to the filter, which is exactly what is, and is supposed to be, happening.
I think you're confused on what sludge is. What's in that filter is not sludge. It's dried solid particles, likely from around the rings. The esters and ANs in that oil is doing what it is designed to do. There is no reason to reduce the OCI here.
If these long intervals are the cause of sludge, why is the sludge being continually removed by the oil filter?And if there is that much sludge and deposits in the engine after running motor oils it's whole life that claim to "remove sludge in just one oil change" that's pretty telling.
If these long intervals are the cause of sludge, why is the sludge being continually removed by the oil filter?
This is hard carbon that is wet with oil. It is not sludge. Hard carbon feels like grit.If this was normal cleaning not only would this not look like sludge but it would be gone in one change.
This is hard carbon that is wet with oil. It is not sludge. Hard carbon feels like grit.
Why would you think the accumulated carbon on the pistons and ring lands would be gone after one oil change?
Yes I have, in fact I have some in the garage right now that came out of a 7.6L engine. Lots of carbon built up on the lands that polished the bores.Have you ever cleaned old pistons before?
I'll bet you cumulatively the oil filters I've changed out since running HPL have had no more than a couple ounces of carbon.There's barely enough to fill an 8 oz cup
What does that mean?much less sludge multiple oil changes.
Deposits is the correct term, not sludge. Specifically carbon deposits on the pistons and ring lands.There's a problem if you're producing that much deposits after a life of using an oil that claims to clean them up in one change.
Yes I have, in fact I have some in the garage right now that came out of a 7.6L engine. Lots of carbon built up on the lands that polished the bores.
I'll bet you cumulatively the oil filters I've changed out since running HPL have had no more than a couple ounces of carbon.
What does that mean?
Deposits is the correct term, not sludge. Specifically carbon deposits on the pistons and ring lands.
I have clearly stated that for 112,000 miles, I ran 10w-30 HDEO in the summer time and 0w-30 in the winter. Neither of these oils were high in AN or esters, so they had less ability to keep high temperature deposits from forming or loosen them after they formed. However, both oils meet API specs.
We have seen time and time again on this forum that the ANs and esters in HPL oils have the ability to loosen deposits left by other oils.
That's great, but your Pentastar is a 2021 with how many miles? How many miles of high speed driving? My Pentastar probably has more miles running across the western US at 80MPH into a headwind locked in 8th gear and foot to the floor, than yours has total. This engine has run at wide open throttle for thousands of miles. Mine is at 153,000 as of today.That's a theory though. I run a high ester oil in my pentastar that claims to clean sludge and you see what mine looks like...
I find this to be complete fantasy. We know that HPL oils are extremely robust, but you want me to believe they are producing deposits and sludge AND cleaning them out? I would love to know how that would work.The alternative theory is that your car is now producing much more deposits and sludge (can be both).
This is not dried solid particles...
View attachment 156200
It's in the process of being dried sludge.
And if there is that much sludge and deposits in the engine after running motor oils it's whole life that claim to "remove sludge in just one oil change" that's pretty telling.
I was referring to the OP's filter, not yours.
Huh?Well I have a competition license so I may be the wrong person to compare to lol.
Heat. Can you imagine the heat rejection from making enough power to 'cruise' at 100 MPH? That's not easy on oil, it's not easy on anything.I regularly run my Durango at 100mph on cruise control but I don't think those highway conditions are hard on the oil at all.
Competition license is a competition racing license.Huh?
Heat. Can you imagine the heat rejection from making enough power to 'cruise' at 100 MPH? That's not easy on oil, it's not easy on anything.