My buddy’s 07 Odyssey had a seeping p/s pump. He is trying to keep this vehicle running at a minimal cost since he plans to replace it this year. A new aftermarket P/S pump is $130, but I found a Gates p/s pump seal kit for $20. Since the pump was quiet and functioned normally, I decided to reseal it with new seals as an experiment.
The shaft seal and pressure relief port o-ring were fine. All other seals were rock-hard and flattened. A brass hammer was the only special tool needed. I followed this video for instructions:
So far, the reseal is successful. I will keep my fingers crossed that it lasts for the remainder of his ownership.
The shaft seal and pressure relief port o-ring were fine. All other seals were rock-hard and flattened. A brass hammer was the only special tool needed. I followed this video for instructions:
So far, the reseal is successful. I will keep my fingers crossed that it lasts for the remainder of his ownership.
Last edited: