Post your latest tractor oil change.

[cb_13]

2005 Mahindra 3525 300 hours
?? Hours on oil
Out ?? And a Mahindra filter

In 5w40 Schaeffers and a Supertech filter

 

[Black Thunder]

2006 New Holland TC30.

Removed blue super tech 3614, drained out rotella 10w30 t5.

Installed new white super tech 3614, filled with Valvoline premium blue 10w30

 

[97prizm]

1956 case 300something. 4 QTS of sae30 chevron supreme and a fram C159 bypass filter. It does not use a full flow filter.

Does Fram make a bypass filter specifically? My relatives all farmed in Kentucky. I don't think I've ever seen a filter that says bypass filter on it.

 

[Black Thunder]

2001 Massey Ferguson 1250

Out. Rotella 10w30 T5, removed blue 3614 supertech

In. Chevron Delo 10w30. New white supertech installed

 

[nwjones18]

Getting ready to do the first full Hydraulic fluid change on my 2015 Kubota L4701. It only has a little over 300 hrs, but figure 10 years is long enough on the original fluid. Had the initial 50hr service done (filters swapped and fluid topped off) by me around 125hrs. Original owner hadn't serviced it. My most expensive oil change to date.. Was $600 + for 11 gallons of Super UDT2, 2 hydraulic filters, one engine oil filter and the outer air filter. I'll use a couple gallons of Delvac 15w-40 from the stash for the engine..

Pained me to spend that much on the fluid, but everything I've read says any other fluid will make the HST transmission loud and potentially damage it... Hopefully I'm not doing it again for another 10 years..

In the past I've just ordered everything from Messicks and had it shipped, but shipping on 10 gallons of fluid got me to go to the local dealer. Their prices were 20% + higher than Messicks, but saving the shipping made it pretty much even.

 

[aba4430]

23 Yanmar SA425; 66.5 hours (completed 50 hour service).

• Out: Rotella T6 15W-40 and Yanmar D68XL65 (119305-35170) filter.
• In: Same, i.e. Rotella T6 15W-40 and Yanmar D68XL65 (119305-35170) filter.
• Also replaced hydraulic fluid and two fluid filters with Yanmar OE filters. Hydraulic fluid used was Rotella HD Tractor Fluid @4.5 gallons.
• Primary and secondary diesel filters and a filter o-ring also replaced with Yanmar OE parts.
• Air filter check/possible replacement, and lubrication of pedals pending.

23 Yanmar SA425; 133.2 hours

• Out: Shell Rotella T6 15W-40 and Yanmar D68XL65 oil filter
• In: The same

 

[Jordan_FX4]

1940 Farmall H

Out: 5 qts Rotella T6 5W-40 + 1 qt HPL EC 30 and Case IH filter

In: 5 qts Valvoline FS Maxlife 10W-30 + 1 qt HPL EC 30 and a Fleetguard LF-584