New Mobil 1 Oil Filters

[ChrisD46]

While at Walmart yesterday I spot checked different size Mobil 1 20,000 mile oil filters and left impressed (visually) at the consistency of the build quality , uniformity , cleanliness and each filter had a plastic seal on the open side.
The area where you screw in the oil filter to your engine was extremely clean , shiny and had zero burrs . The inside leauvers were perfect round openings while the gasket and exterior black cases were perfect (looked like Mobil had each exterior cannister oil filter waxed before leaving the factory). Build wise, this Mobil 1 oil filter was as nice or nicer than my recently bought CarQuest Premium oil filters . I definately would consider using Mobil 1 oil filters in the future once my CarQuest Premium and Fram Endurance oil filter stash is used up .

 

[demarpaint]

Subscribed to find out from our resident filter experts just how good these are. My Ultra stash is just about depleted..........

 

[Dave P.]

For the first time ever, I just used an M1-110A canister filter on my Honda. You're right, the filter felt very substantial and solid. I noticed that the gasket is pre-lubed as well.

 

[GW.]

G

Thread 'New Mobil 1 M-108A made in Vietnam cut open'

Apr 12, 2025

Purchased at Walmart for $11.44.

Definitely gives me Pentius vibes to be honest. Most likely VAFI built(made in Vietnam). Some models are made in South Korea. A little extra glue but otherwise a high quality build. Much better than the previous M+H made Mobil 1 filters. Highline Warren is handling the warranty on these.

Tomorrow I’ll cut out the media and get measurements.

• GW.
• Replies: 120
• Forum: Engine Oil Filters

• 

 

[fantastic]

Mobil has gone to a different supplier with Highline Warren being the warranty company.

 

[53' Stude]

Geez, think we talked about this subject over 20 times already.

 

[leeharvey418]

The inside leauvers were perfect round openings...

Not sure what a leauver is, but assuming that you're talking about the inlet holes - that's what happens when you perf holes in a flat surface and then put an adequately strong pressure pad on top of it while forming in a subsequent operation. That or they perf the holes after form, but that's not how I'd lay out this stamping process.

 

[Dave Hess]

While at Walmart yesterday I spot checked different size Mobil 1 20,000 mile oil filters and left impressed (visually) at the consistency of the build quality , uniformity , cleanliness and each filter had a plastic seal on the open side.
The area where you screw in the oil filter to your engine was extremely clean , shiny and had zero burrs . The inside leauvers were perfect round openings while the gasket and exterior black cases were perfect (looked like Mobil had each exterior cannister oil filter waxed before leaving the factory). Build wise, this Mobil 1 oil filter was as nice or nicer than my recently bought CarQuest Premium oil filters . I definately would consider using Mobil 1 oil filters in the future once my CarQuest Premium and Fram Endurance oil filter stash is used up .

Did the Mobil 1 filter have round holes or louvers ?

 

[Blagoje]

G

Thread 'New Mobil 1 M-108A made in Vietnam cut open'

Apr 12, 2025

Purchased at Walmart for $11.44.

Definitely gives me Pentius vibes to be honest. Most likely VAFI built(made in Vietnam). Some models are made in South Korea. A little extra glue but otherwise a high quality build. Much better than the previous M+H made Mobil 1 filters. Highline Warren is handling the warranty on these.

Tomorrow I’ll cut out the media and get measurements.

• GW.
• Replies: 120
• Forum: Engine Oil Filters

• 

Geez, think we talked about this subject over 20 times already.

Some people just want to be spoon-fed information because using a search function it's just too much work for them

 

[Zee09]

Geez, think we talked about this subject over 20 times already.

No 30 x

 

[Urshurak776]

Did the Mobil 1 filter have round holes or louvers ?

 

[ZeeOSix]

Not sure what a leauver is, but assuming that you're talking about the inlet holes …

Think he's calling holes in the center tube (not base plate) "leauvers".

The old Mobil filters made by M+H have louvers in the center tube, and the new Mobil filters made and handled through Highline Warren have round holes in the center tube.

 

[ChrisD46]

Think he's calling holes in the center tube (not base plate) "leauvers".

The old Mobil filters made by M+H have louvers in the center tube, and the new Mobil filters made and handled through Highline Warren have round holes in the center tube.

Sorry for the delay - inner tube had round holes .

 

[ARCOgraphite]

Sorry for the delay - inner tube had round holes .

Sorry about the flat tire Chris.

"Round holes are for Lovers"
___________________________________________________

 

[ARCOgraphite]

What not run an OEM Hyundai or Mazda filter for something in the 7317 size?

 

[53' Stude]

Sorry for the delay - inner tube had round holes .

I still won’t pay $12 for Mobil 1 name. Especially when I can get CQ premium for $3

 

[ThirdeYe]

I still won’t pay $12 for Mobil 1 name. Especially when I can get CQ premium for $3

Silly question (probably) but where do you get them so cheap? Rockauto?

 

[50yr Street Mech]

Sorry, I don't care who makes the filter. It's not staying on any of my engines for 20k. You can throw all the stats at me you want. Oil change and filter @ 3k. Can't teach an old dog new tricks

 

[ARCOgraphite]

It appears guys here are still afraid to put another marques filter on your car? Will it explode?
You know are doing just that with the "one shoe fits all" aftermarket selection.

Before you comment, I am aware some aftermarket are addressing the std and high bypass settings where spec'd with differing p/n's

 

[ARCOgraphite]

Sorry, I don't care who makes the filter. It's not staying on any of my engines for 20k. You can throw all the stats at me you want. Oil change and filter @ 3k. Can't teach an old dog new tricks

I am retired now and driving about 400 miles a month with not much highway - so I just do only Spring and Fall seasonal changes at about 2500 miles. Sounds insane when I type it out, but direct injection and town crawlin' aint good for the oil and engine.