How to install this manual choke lever? (Briggs 10.5hp recoil start)

[sh40674]

I have a swisher finish mower I got cheap a few years back to mow spots on my hunting property. The mower is stored there so I don't have it at home to tinker with.

When I got it I replaced the carb, it had been sitting a while and was really corroded inside. The replacement was a Nikki, old carb was a walbro.

Well, since it's an older mower basically only 1 replacement carb and no manual choke lever (old one had one but was a different style). So since I only use it a out 5 times a year I just wedge a stick in to hold the choke open to start. We'll, that's getting old. I looked up the manual and found the part I need (#951 below the diagrams of the carbs is the lever kit) and found a Chinese job on ebay I took a screen shot of to show the style of carb I have and the lever (you see the lever and the block with spring on the left side)

How does this install? Does anyone have a pic, step by step or video that shows? I'd rather not drive an hour to my property just to be confused about it lol. Thanks in advance!

 

[sh40674]

Well if anyone happens to have my same issue, figured it out. I went up to my property with the new choke lever. Not only that but I realized the original choke wire is missing (it's the type you pull the throttle past full and it starts to choke)

I guess I never paid attention to it. Only use it about 5 times a year. Dumb on me. Either way, one look at the mower and I quickly realized the clamp piece screws onto the intake tube. Easy peasy. So if you need a manual choke installed here ya go