OVERKILL
$100 Site Donor 2021
Originally Posted by SubieRubyRoo
Originally Posted by Bailes1992
I always thought that anything more than 100ppm of Moly was a waste?
I'm pretty sure I remember reading in a research paper posted on here a while back that moly really doesn't start to show real friction reduction benefits until it is OVER 200 ppm. There were a couple other "benefits" to higher moly... as long as the base oil will keep it in suspension.
I believe that's for "conventional" moly. Tri-nuclear requires a significantly lower treat rate for the same level of effectiveness.
Originally Posted by Bailes1992
I always thought that anything more than 100ppm of Moly was a waste?
I'm pretty sure I remember reading in a research paper posted on here a while back that moly really doesn't start to show real friction reduction benefits until it is OVER 200 ppm. There were a couple other "benefits" to higher moly... as long as the base oil will keep it in suspension.
I believe that's for "conventional" moly. Tri-nuclear requires a significantly lower treat rate for the same level of effectiveness.