From the DIY I have read I will need jack stands, a jack,
32mm socket
19mm socket
17mm socket
17mm wrench or additional socket
1/2'' driver for big sockets
3/8'' driver for drain plug/sockets
hammer
****s
prybar
*big- breaker/cheater bar for the 1/2'' driver to break the axle nut loose and tighten it back down*
If all of that is going to cost me under $100 then I'll prob do it myself but if not...
And here are some of the DIY I was looking at:
http://honda-tech.com/showthread.php?t=382416
http://www.clubintegra.com/board/showthread.php?t=63748
http://www.youtube.com/watch?v=9WO9dAhb9fQ
32mm socket
19mm socket
17mm socket
17mm wrench or additional socket
1/2'' driver for big sockets
3/8'' driver for drain plug/sockets
hammer
****s
prybar
*big- breaker/cheater bar for the 1/2'' driver to break the axle nut loose and tighten it back down*
If all of that is going to cost me under $100 then I'll prob do it myself but if not...
And here are some of the DIY I was looking at:
http://honda-tech.com/showthread.php?t=382416
http://www.clubintegra.com/board/showthread.php?t=63748
http://www.youtube.com/watch?v=9WO9dAhb9fQ