2006 Jeep grand cherokee hemi

Status
Not open for further replies.
Joined
Feb 3, 2011
Messages
1,426
Location
Golden Meadow, LA
just changed the oil for a buddy of mine, grand cherokee with the 5.7 Hemi, 33,000 miles. I used Quaker State Synthetic 5w20 and a Mopar filter, 7 quarts, like it calls for. i let it sit for about 15 mins, and when i checked it, it was only halfway on the safe mark. I went read on some forums, and it says the hemi takes 7.5, sometimes 8 quarts, to reach the full mark. Should this be a cause for concern? Will it be safe with 7 or should i put another 1/2 qt?
 
Last edited:
So you're concerned that the dipstick is showing the oil to be right in the middle of the range the manufacturer recommends? Oy vey!
 
I have had 2 5.7L HEMI Ram's and they always took 7qts at an OC just like it calls for in the OM. IF the OM for the Jeep says 7 qts that is what you use. I wouldn't listen to anyone saying use 8 qts.
 
Last edited:
I've heard it all now.

Measure the amount carefully. Use what the book says. BTW, virtually every newer Hemi takes 7 quarts.

The dipstick can move around, the oil can stay up in a head for a lot longer than 15 minutes. Trust your measurements.
 
I have dealt with numerous engines where you fill it to the specification in the owner's manual, but the dipstick shows either too much or too little oil.

I don't know why this happens.
 
Me, too, hence my advice above^

Seen a ton of engines with the tube either partially pulled out of the block or not seated properly to begin with.

Actually bought a used car with a non-original dipstick once. Took a while to figure that one out.
 
Status
Not open for further replies.
Back
Top Bottom