Update on Fram AirHog

Status
Not open for further replies.
Joined
Aug 30, 2004
Messages
35,293
Location
CA
Two days ago, I finally received the Fram AirHog I ordered from RockAuto.

Last night, I installed the new filter. There was a light coating of oil on the "dirty" side of the filter, and the rubber gaskets seem to be fairly thick and of decent quality. There were a few misaligned pleats, but I wasn't too concerned about it.

The air filter it replaced, a STP (I think) with 25k miles and 30 months, was completely gray on the "dirty" side. Previously, with the STP filter, I would be able to fit the airbox cover over the filter and engage the clips with one finger. Now, with the AirHog, it takes considerable effort to engage the clips. I guess this new filter seals a lot better.
 
Well, I hope the Hogg isn't so out of spec that your clips break!
crazy.gif


Keep an eye on em, I ran a Fram that was too thick at the seal, and one of mine broke quite a while after I installed it with the clips VERY hard to snap in. That end of the filter housing was open for however long it was. No harm I'm aware of, but who needs it?
dunno.gif
 
Status
Not open for further replies.
Back
Top Bottom