Hey everyone, im replacing the steering rack in my dad's toyota camry, and i'm at a point where i can't go any further. The 9th step in my chiltons manual says to "loosen the upper bolt and remove the lower bolt holding the control valve shaft to the intermediate shaft. First off, i looked for an hour and cannot find the "upper bolt". I found the lower one, and removed it. It then says to remove the intermediate shaft from the rack. Honestly this "intermediate shaft" is not going anywhere. It has no play whatsoever. If i can somehow get this shaft out i can proceed.
Also the next step says remove the nut to the tube clamp, and remove the clamp from the vehicle. Looking around, i have no clue what they are talking about. The only things left are the fluid lines and those are covered on down the page.
Also the next step says remove the nut to the tube clamp, and remove the clamp from the vehicle. Looking around, i have no clue what they are talking about. The only things left are the fluid lines and those are covered on down the page.