Sometimes you can get a fair amount by shifting subframes or just loosening struts, moving and tightening again... sometimes not...
I did and it says, Installing aftermarket cam bolts. If that was needed, you have bent suspension components or a bent frame. Not within the scope of a normal alignment.From the article you linked. It might be useful to read the entire article that you're referencing.:
Adjustments
The Camry has very few factory adjustments outside of the toe angle. Installing aftermarket cam bolts on the struts can give some adjustability, but they are not substitutes for worn bushings or broken springs.
Adjustment of front camber requires the use of cam bolts. The bolts allow both positive and negative camber changes up to approximately 1.75º. The bolts require .4 hours of labor to install per side. Front caster is non-adjustable.
Adjustment of rear camber requires the use of cam bolts. The bolts allow both positive and negative camber changes up to approximately 1.75º. The bolts require .4 hours of labor to install per side.
After lunch, you can reset pressures again.Thanks for all the comments and input. I've certainly learned a few things. Time for lunch.
Ive experienced this with an accord which was a little off. Techs have limited patience when making adjustments tapping the cradle around. It’s imprecise guesswork, difficult to dial in. The issue only revealed with higher performance tires.
Sometimes you can get a fair amount by shifting subframes or just loosening struts, moving and tightening again... sometimes not...
Many years ago, between 1957 and 1960, Road & Track published an article suggesting adding some weight to the driver's area when doing an alignment.I like to sit in the driver's seat during the alignment.
Weighted alignment makes a lot of sense if the vehicle is consistently weighted, as is the case with a race or track car without passengers or cargo. With a daily driver I have the alignment done with the usual cargo in the trunk and with either myself or with an equivalent mass in the driver's seat. The extra effort is minimal, so why not do it? Camber, especially rear camber is what gets mostly affected by weight.Many years ago, between 1957 and 1960, Road & Track published an article suggesting adding some weight to the driver's area when doing an alignment.
From the factory, there are no such adjustments for that vehicle. It is toe only.