Post your latest small engine oil change

Harbor Freight Predator generator 420cc 5500 running watts 13hp.

Out was a mix of M1 TDT 5w40 and Mobil SS 5w30. I figure that oil was in it about 15 months. Only had to use the generator twice for actual power outages (several hours each) but run it every month for at least 30 minutes with about 2500 watts on it. Oil changes on this are super simple and quick, only takes like 33oz and 5 minutes.

In: About a 50/50 mix of M1 5w30 HM and M1 10w40 4T. This is what I had sitting around as partial quarts and sounded good.
 
Ariens ZTR 1742 - Zero Turn Mower
Repowered a few years ago with a Briggs Intek 21.0 HP 330000 540CC
Given to me by a co worker who stated it didn't run anymore.
Starter solenoid was bad.

Out - Unknown fill and Yellow Briggs oil filter

In - Rotella T Triple 15W40 and a Motorcraft FL-910S
 
Last edited:
2000 MTD Agway tractor with Briggs and Stratton 12.5hp engine

Out: Black sludge
In: Rotella T 15w40


1972 Ariens snowblower - Tecumseh 7hp snow king engine

Out: Napa 5w30
In: Valvoline MaxLife 5w30
 
Toro 22" Recycler walk behind.

Out: M1 5w30

In: The bottle of Toro 30 weight oil that came boxed with the mower when new that I didn't notice until after I put the M1 in!
 
Craftsman YT with Kohler Courage. Out, Delo 30 wt, and MC FL-910. Back in with the same, but added about an ounce of Lubro-Moly MOS2. Seasonal change, a summers worth of lawn mowing.
 
Champion 2kw Inverter generator - like JR previous post.

Out: Rotella 5w-40
In: Rotella 15w-40 (they didn't have the 5w-40 & I didn't feel like making a run to a different store).

Ran almost half hour under varying load (warm up 5 or so minutes no load, then 500w to 1200w then no load maybe 3-5 minutes), drained oil, add oil, cleaned up & 303 on the outside, then ran again about 10 minutes @ 500w load.

Fresh fuel & using blue Stabil.
 
Last edited:
Errtt, how many hours on the invert? Mine will pull hot box duty for the powerstroke, will see 42-45hour min a week.

JD-TEK jd1200s
Out: unknown
In: qsgb 5w-30 and mmo

General 90's model
Out: M1 0w30; 6month and less then 15hrs
In: same as drain

Onan powered Miller welder/gen
Out: unknown oil, filter, and hours
In: St 15w-40, mmo, and hm1a


Craftsman Dr trimmer. Tecuseh 6.5hp
Out: qsgb 5w-20 and mmo; 10hrs
In: m1 ep 0w-20/ 15w-50



Harvey
 
ExMark walk-behind
15 hp Kawi 48"
Rotella T6 5W-40 and M1 filter (good filter sale) in & out

ExMark walk-behind 36"
12.5 Kawi
Same as above
 
JR --- Don't know, I don't track it well, just a rough estimate by guess I'd say 94 hours total on it. Guessing >90% monthly exercise test, rest actual home usage.
If I run it for 2 hours ~ 15 minutes, I'll call it 2.5 hours (most times round up). 2 hours and 5 minutes I'll call it 2 hours. After each run, I'll add the new run time (using a grease pencil (china marker)) I write it on the housing, rub/wipe off, write new figure.
Although not many hours, when I do run it it has never failed to start (one, on occasion a 2nd pull, turn on fuel wait a minute, then start). Running, it has never missed a beat.
 
Last edited:
Riding lawnmower, 20 hp v twin B&S, 2 year oil change

out SuperTech 10/30 dino and P classic filter

in SuperTech 10/30 dino and MC 910s filter

Will go again 2 year run. Oil was clean when changed.
 
Honda gc160, auction house special. Runs great, gen makes no power.
Out: unknown, dark but not black
In: Mobil dino 10w-30 and mmo, flush fill


Tecumseh premier1 5hp
Out: unknown
In: qsgb .5w-30


Kubota em300-as, ?meter reads 850hrs?
Out: m1 15w/20w-50 and mmo; 24hrs under 1.5kw gen load, flush fill
In: d1 5w-40
 
'99 Craftsman GT with 20hp Kohler

out - 2.1 qts Shell Rotella T5 10w30 with NAPA 1348 Gold

in - 2.1 qts Shell Rotella T5 10w30 with NAPA 1348 Gold

Cleanest looking change since I've owned it...
 
Back
Top Bottom