Michelin CrossClimate2 wear concerns

Joined
Aug 15, 2009
Messages
525
Location
Colorado
I'm curious if anyone else had issues with the CrossClimate2 wearing faster on outer tread vs the center? Yes, I'm running them at the correct PSI and the alignment is good. This is on a 2017 Toyota Highlander and I'm wondering if it's an issue for anyone else with a Highlander or similar SUV? I've also got these tires on an old Forester and am not having the same issue.
 
I'm running the CrossClimate 2 on my Lexus RX350. Got 60k out of the first set of CC2's on the same vehicle. No issues with outer tread wear on either set. I do run them 2 lbs. over Lexus recommended pressure at 35psi.
 
36PSI is the recommended pressure on all four. I run them 38 to 39. Center tread is currently 5/32 and it trends down to 2/32 toward the outer. I might go back to Defenders or perhaps try something different like Pirelli's all weather. Perhaps it's a byproduct of the type driving we do which is city. Roads in my city are kind of garbage.
 
The Highlander is a pretty heavy vehicle. The Cross Climate 2 would not be the tire I would pick for that particular vehicle. The Defender would be a much better fit.
 
The Highlander is a pretty heavy vehicle. The Cross Climate 2 would not be the tire I would pick for that particular vehicle. The Defender would be a much better fit.
There is nothing to suggest that one tire will be superior to the other for a heavy vehicle.
 
Just saying it is aligned means nothing with out a time frame of when it was checked or adjusted and what are the TOE and CAMBER of both the front wheels were finally set at, AND in what shape are the tie rods and upper/lower ball joints in at your 90,000 miles? You could have a mess for all we know. If they have not been replaced yet, this could be another large deviation in suspension integrity. Factory allowable deviation is way too broad and almost every "common" alignment even new can have a large deviation swing as many, but not all, follow wide factory deviation too. Some alignment guys will give you a fairly accurate toe and will not adjust camber as long as it is in the wide swing of factory allowable deviation. High-performance alignments will hit exactly what you want as long as it is in the car adjustment spectrum, and of course cost more. Some shops say they did an alignment and actually did no adjustments and the car/truck could be a good way out of an accurate high quality alignment you should be at if you are hunting for why you are having tire wear. Those tires are not the best choice for a long wearing tire for that truck, as it heavy and I bet puts high load on those tire even in common driving. Thin long syped soft tire against a larger stiffer block lug tire the Defender is.

While other posters suggestions may help, but it is a crap shoot that will need a lot of time and more tire wear to test, and then it subjective as to your memory 2 months later. Knowing your exact alignment specs can help pin it down way way faster. The first place I would look is camber on that front tire. Might that be on the side you may be going on the load side of a exit ramps that you might have a large # you drive on daily to work??? Just throwing that out as a possibility.
 
Last edited:
Back
Top Bottom