Got a slight issue with my Grand Marquis, which started last night. I had half a tank of gas, and the car was left to sit for a couple of hours. When I started her up, the gauge was reading full. I checked my ScanGauge-II and the FLV gauge was reading 1.00 (full).
Thought it was pretty weird, but I drove off and noticed the gauge was now reading 1/8 on the gauge and 0.8 on my SG-II. It kept dropping and after 10 minutes or so, it read half on the gauge and 0.54 on the SG-II, which was the correct reading before the car was parked.
Not sure if this has anything to do with it, but I switched from high sulfur gas (500 ppm) to Euro V gas (10 ppm sulfur limit) recently.
Thought it was pretty weird, but I drove off and noticed the gauge was now reading 1/8 on the gauge and 0.8 on my SG-II. It kept dropping and after 10 minutes or so, it read half on the gauge and 0.54 on the SG-II, which was the correct reading before the car was parked.
Not sure if this has anything to do with it, but I switched from high sulfur gas (500 ppm) to Euro V gas (10 ppm sulfur limit) recently.