Number_35
Thread starter
Did a bit more work on the CR-V earlier today.
- Changed a very overdue cabin filter (Post #27):
https://bobistheoilguy.com/forums/threads/cabin-filters-nsfb-not-safe-for-bitog.339077/page-2
- Took off the driver's door panel, in preparation for replacing the PW ass'y.
- Was able to reinstall, without replacing, a front stabilizer-bar end-link which had come half-off. The top stud had come right out of the mounting point after losing its nut, and the nut on the bottom stud (which is attached to the stabilizer bar) had worked half off. Measured the stud diameter and thread pitch (10 x 1.25) and had an appropriate shouldered nut in my collection, so the top was easy. Can't say for sure it was the AeroKroil, but I was amazed that on the bottom I was able to hold the stud with a 5 mm hex key in the end of the stud, and retighten the nut to secure the bottom stud to the stabilizer bar. I was almost certain I'd have to cut the stud off and replace the entire unit.
- Now need to source a driver's-side PW motor and regulator assembly. Here are some choices from RA. Please advise! Aisin?
https://www.rockauto.com/en/catalog...erior,window+regulator+&+motor+assembly,15596
- Changed a very overdue cabin filter (Post #27):
https://bobistheoilguy.com/forums/threads/cabin-filters-nsfb-not-safe-for-bitog.339077/page-2
- Took off the driver's door panel, in preparation for replacing the PW ass'y.
- Was able to reinstall, without replacing, a front stabilizer-bar end-link which had come half-off. The top stud had come right out of the mounting point after losing its nut, and the nut on the bottom stud (which is attached to the stabilizer bar) had worked half off. Measured the stud diameter and thread pitch (10 x 1.25) and had an appropriate shouldered nut in my collection, so the top was easy. Can't say for sure it was the AeroKroil, but I was amazed that on the bottom I was able to hold the stud with a 5 mm hex key in the end of the stud, and retighten the nut to secure the bottom stud to the stabilizer bar. I was almost certain I'd have to cut the stud off and replace the entire unit.
- Now need to source a driver's-side PW motor and regulator assembly. Here are some choices from RA. Please advise! Aisin?
https://www.rockauto.com/en/catalog...erior,window+regulator+&+motor+assembly,15596