'17 Ram Ecodiesel 3.0 - 7501 miles CP Triton 5w40 1300 PPM Zinc

[jayg]

Thank you for your clarification. In this case I may only guess why about 100 ppm of Titanium are missing. Another issue is a huge drop in both viscosities: according to PDS [email protected] should be about 96 cSt and [email protected] - about 14.5 cSt. Before 2017 they specified respectively 95 and 15.1. Fuel content is low. Have you used a low viscosity oil for the previous fill ? I don't believe Triton could shear in this way.

Factory fill was RT6 5w40 then Triton for every change up to this UOA.

 

[Primus]

Hi, thank you. Then the drop in both viscosities is either caused by fuel (despite UOA did not show it), or the engine is tough on oil. As for Titanium, it seems at time of your purchase it was not simply added to Triton ECT. Have a great week-end !

 

[jayg]

Rather than start a new thread, I’m attaching my latest UOA for the truck. 10,022 miles on Delvac 5w40. Temps from 85f to -48f. Tune is still flawless and starts unassisted if needed and even with extended idling in winter to warm up its holding up well.

I replaced the oil with Rotella T6 5w40 since we had a shortage of anything but 15w40. I’m sure it will be fine.

 

[FZ1]

Rather than start a new thread, I’m attaching my latest UOA for the truck. 10,022 miles on Delvac 5w40. Temps from 85f to -48f. Tune is still flawless and starts unassisted if needed and even with extended idling in winter to warm up its holding up well.

I replaced the oil with Rotella T6 5w40 since we had a shortage of anything but 15w40. I’m sure it will be fine.

View attachment 92227

Good consistent runs.