Search results

  1. C

    99 Nissan Altima Clunk

    I hope that is all it is. Seems to happen when it sits for a while when the temperature is below 30 degrees. Above 30 it never seems to happen.
  2. C

    99 Nissan Altima Clunk

    I have a 99 nissan Altima that seems to shift from park to drive or reverse with a clunk when cold. It will only do this when it gets real cold outside and it has been sitting. Otherwise it runs and shift perfectly fine any other time. It has been well maintain with regular fluid changes and no...
  3. C

    wet plugs

    I had a 94 Nissan Sentra. It was a problem that Nissan had, and there was a bulletin on it. I am not sure what the fix was, but mine did it twice in the 170,000 miles I drove it. It eventually started and ran rough until it burned off the gas and was fine. Very frustrating at the time, but I...
  4. C

    Starting problems

    Anyone??
  5. C

    Starting problems

    Thanks, I will see about the power to the coil. I did clean the ground on the engine. Could the ignition where the key is be the problem even if it turns the engine over?
  6. C

    Starting problems

    This might be a little long, but I have an I/O engine that is a 1980 GM Block, I believe to be a 1.6L, Chevette engine. It has sat for 5 years. I have replaced the starter solenoids, which were shot from moisture. It turns over fine, and has fresh gas in the tank. My problem is that it doesn't...
  7. C

    Reviving stored engine

    Oops, I forgot to mention. It is an OMC sterndrive.
  8. C

    Reviving stored engine

    Where is the impeller on a 1980 sterndrive? How involved is it to change?
  9. C

    Reviving stored engine

    I have been given a 1980 Rinker with an OMC I/O 140hp 4 cylinder engine. It has not been used for 4 years. What do I need to do before I try to start it? Gas was drained, and it was winterized before it was stored last. Also, what oil filters can I use on this engine. I know it is a GM block...
  10. C

    Quaker state atf

    What do you know about the quality of quaker state dexron III atf? Is it any good? I have been using Valvoline with no problems, but saw gallon jugs of quaker state for $6.77. Any help would be appreciated.
  11. C

    Quicksilver 2 cycle oil

    I have a 2001 200hp carburated Merc that has seen nothing but the quicksilver 2 cycle oil since new. I run it as a charter boat, so the engine gets many hours of running each year. Currently I think the engine has 2000+ hours on it. With all of that running, I go through my share of oil. Are...
  12. C

    hose lifespan

    What is the average lifespan of radiator and heater hoses? Mine seem to look fine and do not seem to be mushy or cracked. I have stayed up to date with my flushes, and have never had any leaks. I am sure I am close (4 yrs.), but was hoping since they have been maintained well, that I might be...
  13. C

    Removing rear drums

    Thanks guys, I will give it a try! Chinook
  14. C

    Removing rear drums

    I have a 99 Altima and was wondering how to remove the rear brake drums to check the condition of the brakes. Any advice or tricks would be greatly appreciated.
  15. C

    Hard shift

    I did use the Dextron III that it calls for. Other than when it is real cold, it seems to always shift just fine with no other problems.
  16. C

    Hard shift

    I have a 99 Nissan Altima with auto, that when it is cold, below 20 degrees, shifts into gear a little harder than when it is warm. The transmission seems to perform just fine when driving, and shifts from park to reverse or drive just fine when it is warmer. It just shifts from park to reverse...
  17. C

    struts

    What is the approximate lifetime of a set of struts? I know they last longer than shocks, but how long? Do you do the same bounce test that you do with shocks?
  18. C

    Leaking purolator

    Good point about the crimp. I will check that. I was just assuming that it was the seal.
  19. C

    Leaking purolator

    I know its not double gaskets.
  20. C

    Leaking purolator

    Has anyone had this problem? This is the second time I have had a purolator oil filter leak on me. Its not a big leak, but more of a seep. Are their seals not very good? It is definitely on tight enough and I put a film of oil on it before putting it on. I use the premium plus. What other...
Back
Top Bottom