Subaru AC Compressor Clutch Air Gap

[HowAboutThis]

AC worked for about 5 minutes then started blowing warm. Stopped a few minutes for errands, got in, blew cold for about 5 minutes then started blowing warm. Repeat.

Long story short, after some Internet searches, popped the clutch off the compressor and removed the smallest shim to get the air gap back to 0.35mm and it seems to be blowing cold again. Aside from needing figure out what tools I needed, about a 15 minute job. But, of course, took some tool shopping and about 2.5 hours

 

[charbaby]

I’ve done the same on other vehicles as they aged.

 

[HowAboutThis]

I’ve done the same on other vehicles as they aged.

I've never done it before. Maybe just lucky? I knew they wore, but this Subaru seems to be wearing bearings, axles, lug studs, batteries, AC gap, etc. every 75-125k. That's sooner than any Honda or Nissan or Toyota I've owned in the past from my memory. We'll see what wears out next. I don't expect things to last forever, but I feel like other Japanese brands I've owned go well past 150k before things start nickel and diming. Even the early 2000s Forester we had---head gasket--- but I can't recall anything else wearing and we sold it near 200k. Same bearings, axles, lug studs, batteries lasted reasonably long, etc.

Just seems early to me from what I can recall ever messing with on vehicles I had previously. I can't imagine other brands are much more "needy" than this Subaru for some of these things.

 

[IndyIan]

Which one is this? I do find the lug studs are fine as long as I'm swapping tires, or my local mechanic, but the one time I get winter tires put on the car at a tire shop, the tech stripped 2 lugs on the same wheel before he learned to slow down the impact. At least you can change them easily without removing anything else.
I've done the two rear wheel bearings in our 2018 Outback at 130k, and a rear diff axle seal, and front ball joints at 120k. The rear strut mounts are creaking now, but spraying some rust proofing oil up there seems to have quieted that down. Also there was a battery recall for it, as it was a bit small for the electrical loads and how the charging algorithm is programmed. Also the muffler rusted out.
My parents 2016 Forester has 110k on it now and hasn't needed too much other than a valve body replacement, for a bad solenoid.
I have a 2016 Impreza with 50k miles and it just needed the AC condenser done, front sway bar links(bad design) and a couple A arm bushings.
Heat shields are becoming rusty and rattling, on all of them, so I've done some hose clamping. But that seems pretty common at this age up here with our other cars, just the subarus have more of them than our inline 4 cars.

 

[HowAboutThis]

Which one is this? I do find the lug studs are fine as long as I'm swapping tires, or my local mechanic, but the one time I get winter tires put on the car at a tire shop, the tech stripped 2 lugs on the same wheel before he learned to slow down the impact. At least you can change them easily without removing anything else.
I've done the two rear wheel bearings in our 2018 Outback at 130k, and a rear diff axle seal, and front ball joints at 120k. The rear strut mounts are creaking now, but spraying some rust proofing oil up there seems to have quieted that down. Also there was a battery recall for it, as it was a bit small for the electrical loads and how the charging algorithm is programmed. Also the muffler rusted out.
My parents 2016 Forester has 110k on it now and hasn't needed too much other than a valve body replacement, for a bad solenoid.
I have a 2016 Impreza with 50k miles and it just needed the AC condenser done, front sway bar links(bad design) and a couple A arm bushings.
Heat shields are becoming rusty and rattling, on all of them, so I've done some hose clamping. But that seems pretty common at this age up here with our other cars, just the subarus have more of them than our inline 4 cars.

17 Forester for us.

Reading your list, and other Internet forums, seems to be the trend...at least the online trend. Much of what you mentioned (and I've experienced) just feels "too soon" to me for such a highly rated brand for "reliability".

Just talking with two neighbors with caravans. I think they replace fewer parts than I have on this Subaru and often those minivans get rated mid level for reliability.

Or maybe with all the magazine hype for reliability, my expectations are just too high so there's nowhere for me to be but disappointed