The parents need a new garage door - CA state law mandates battery backup openers installed after 7/2021. One garage door installer said we must install a new opener, the other one we went with said they’ll install a new door but won’t connect it(it’s a less than 5 minute job).
The current opener is a LiftMaster 3265 manufactured and installed in 2007. The salesman who came out told me these were solid openers and doesn’t see much of a reason to upgrade. It’s a chain drive model. Parts - mainly the worm gear and sprocket, control board and limit switch assembly are still available. Common Chamberlain fare. A new opener, likely a LiftMaster belt drive is around $1000 installed. The new door was $3300, about that I expected($3K for an insulated steel door) for a HCOL area. Should I go ahead and keep this opener until it croaks or replace it? The current LiftMaster chain drives still use the same chain/rail assembly, and it does look like a Chamberlain head will be a direct bolt-on, unless I can sell my parents a jackshaft mounted one. But if we don’t need to spend $250-550(DIY Chamberlain chain or jackshaft, if we’re going belt, it’s another LiftMaster for the one-piece rail), that’s always a plus.
The current opener is a LiftMaster 3265 manufactured and installed in 2007. The salesman who came out told me these were solid openers and doesn’t see much of a reason to upgrade. It’s a chain drive model. Parts - mainly the worm gear and sprocket, control board and limit switch assembly are still available. Common Chamberlain fare. A new opener, likely a LiftMaster belt drive is around $1000 installed. The new door was $3300, about that I expected($3K for an insulated steel door) for a HCOL area. Should I go ahead and keep this opener until it croaks or replace it? The current LiftMaster chain drives still use the same chain/rail assembly, and it does look like a Chamberlain head will be a direct bolt-on, unless I can sell my parents a jackshaft mounted one. But if we don’t need to spend $250-550(DIY Chamberlain chain or jackshaft, if we’re going belt, it’s another LiftMaster for the one-piece rail), that’s always a plus.