Finished my AUTO-RX, when to re-appy?

Status
Not open for further replies.
Joined
Jul 7, 2005
Messages
17
Location
Montreal
Just finished my RX treatment..all is good and clean... My rinse phase is also over and I now switched to Esso XD-3 Synthetic oil and I am also using LC.

SO my question is, when should I reapply with Auto-Rx??
 
A synth with a reasonable OCI = NEVER
A synth + LC = NEVER
A synth + maintenance dose = Never

If no LC/neutra, if unreasonable OCI, if no maintenance dose, if no synthetic, then you'll probably need it sooner then never
grin.gif
 
..but if I add the maintenance dose, then there is no need for LC?..I'm planning OCI every 8,000 miles.

Do you guys use LC or the maintenance dosage of RX?


thanks
 
Little side benefit of running ARX maintenance dose is that it actually enhances lubricity. Some of the components in ARX are actually used as friction reducers in industry.
 
quote:

Originally posted by unDummy:
A synth with a reasonable OCI = NEVER
A synth + LC = NEVER
A synth + maintenance dose = Never

If no LC/neutra, if unreasonable OCI, if no maintenance dose, if no synthetic, then you'll probably need it sooner then never
grin.gif


Says it all...

Id personally go the LC route.

Id like to go LC + RX but need data before doing that.

I did put LC and RX into my BMW... to see the results next UOA (the BMW had an RX procedure done some time back, was before and still is perfectly clean, and runs well).

JMH
 
Status
Not open for further replies.
Back
Top Bottom