Thought you guys might like to see this. I purchased this truck Tuesday and drove it home about 250 miles. It has an EM-7 Maxidyne engine, T2070 Maxitorque transmission, 44,000lb Mack Camelback suspension and Mack axles. The steer axle is a 20,000lb axle and the pusher axle is the same. The last 2 photos show the progress of removing the front mount hydraulic pump and fenders in preparation for the mixer body to come off. This truck is getting a 16-18' dump bed installed. I am tired of running the wheels off my single axle and decided to build a dump. Was able to buy this for 1/3 of the same truck with a dump bed, sold the mixer after owning the truck less than 18hrs. The sale of the mixer will buy a good used dump bed. I'll have less than half of what the comparable dump truck is worth. It is a little gear bound on the interstate but runs 55-60 just fine. There's not an interstate within 40 miles of me so the gearing will not be a concern. I am doing all the work myself so far except for needing my dad to pitch in and run the skidsteer when I couldn't be in both places at once.