Checking the Oil

Status
Not open for further replies.
On a normal vehicle, ten to fifteen minutes is plenty of time. Some vehicles, Ford I think, have a longer time to wait. I find it safe to check after five minutes hot and just coming off the highway.
I also fine a difference in level between checking cold and hot (like an auto trans). I check mine hot.
 
I wonder how many engines had too much oil after stopping at a full-service gas station in "the good old days".

I remember working at my Uncle's Union 76 Station as a kid. We checked the air pressure in the customers' tires as well as the oil while I was filling their tank with gas. I remember pulling the dipstick and telling (and sometimes showing) the customer, "You're about 1 quart low..."

:oops:

Ed
 
What does your owners manual say? Most say bring the car up to operating temp, then wait at least 5 mins for the oil to drain back down and check it. I get the oil hot, and wait about 10 mins before checking it.

You could check it cold, but don't be surprised if the level is a tad below the full mark.
 
What does your owners manual say? Most say bring the car up to operating temp, then wait at least 5 mins for the oil to drain back down and check it. I get the oil hot, and wait about 10 mins before checking it.
'Most say'? I've never seen one that says that.
 
I always check in the morning dead cold. There are vehicles that call to be checked hot though. Harley motorcycles (dry sump) should be checked hot.
 
I check mine after sitting overnight, or at least 4 hours--like at lunchtime while at work, when I just want an excuse to go outside. Just easiest that way.

I'm sure there is some exotic out there that has to be checked 3 minutes after shutting down--or while running--but I'm not sure this method fails on any other engine. Reading the owners manual is best but... this seems like a fail-safe way. [Ok, I see Lyman's thread about Harley's being checked hot, got me there.] I also don't think +/-0.5 quart on the typical auto sump will matter, not unless if you have a 3 quart sump, and even then it likely doesn't matter.
 
Not all cars say check it after the car has been at operating temperature, but many do.


Mazda 3 Owners Manual: Inspecting Engine Oil Level
  1. Be sure the vehicle is on a level surface.
  2. Warm up the engine to normal operating temperature.
  3. Turn it off and wait at least 5 minutes for the oil to return to the oil pan.
  4. Pull out the dipstick, wipe it clean, and reinsert it fully.
 
I find zero difference in oil level between a hot or cold engine on either of our cars. As long as I wait for oil to drain back when hot (15-10 min usually).
 
On my Rogue the difference between hot ↑ (10 minutes after shut down) and cold ↓ (first thing in the morning) is about 1/8 inch on the dip stick.
 
Status
Not open for further replies.
Back
Top Bottom