http://en.wikipedia.org/wiki/Mercedes-Benz_450SEL_6.9
The following was quoted from the above article:
The M-100 Powerplant
The engine was a cast iron V8 with single overhead camshafts operating sodium-filled valves (as are found in piston-driven aircraft) against hardened valve seats on each aluminium alloy cylinder head. Each hand-built unit was bench-tested for 265 minutes, 40 of which were under full load. Bosch "K-Jetronic" electromechanical fuel injection was standard at a time when fuel-injected cars were uncommon. As in all Mercedes-Benz automobile engines, the crankshaft, connecting rods and pistons were forged instead of cast. In non-US trim, the 6.9 L (6814 cc or 417 in³) power plant was conservatively rated at 286 hp (213 kW) with 405 ft·lbf (549 N·m) of torque helping to compensate for the 2.65 to 1 final drive ratio necessary for sustained high-speed cruising.
The North American version, introduced in 1977, was only slightly less powerful at 250 hp (186 kW) and 360 ft·lbf (488 N·m) of torque due to more stringent emissions control requirements. In the interest of both engine longevity as well as creating some extra space under the hood, a "dry sump" engine lubrication system was used. Dry sump lubrication was originally developed for use in race cars as a way to prevent foaming of the engine oil by the crankshaft, which in turn would create a serious drop in oil pressure. The system circulated twelve liters of oil between the storage tank and the engine, as opposed to the usual four or five liters found in V8s with a standard oil pan and oil pump.
As a result, the engine itself had no dipstick for checking the oil level. Rather, the dipstick was attached to the inside of the tank's filler cap (accessible from the engine compartment) and the oil level was checked with the engine running and at operating temperature. The dry sump system also had the benefit of extending the oil change interval to 12,500 miles (20,000 km). This, along with hydraulic valve lifters which required no adjusting and special cylinder head gaskets which eliminated the need for periodic retorquing of the head bolts, made the 6.9 nearly maintenance-free for its first 50,000 miles (80,500 km). The 6.9 required little basic service other than coolant, minor tune-ups, oil changes, and replacement of the air, fuel, oil and power steering filters.
An owner's club of this vintage will be queried as to the factory fill...
