I have a Temco TH0005 hydraulic hex die crimper and was wondering if it can be used as a brass ferrule crimping tool for air compressor fittings.
This is the tool and dies it uses.
I've seen ferrule dies that are similar but unsure if they would fit. Could I use a hex crimp on an brass ferrule for air hoses?
This is the die I would like to use if it would fit in my crimper...just can't find dimensional info on these dies.
If anyone has a Milton crimper with dies can you give me the measurements of the dies?
Unless a hex crimp would work but I'm thinking these dies work with the barbed fitting.
This is the tool and dies it uses.
I've seen ferrule dies that are similar but unsure if they would fit. Could I use a hex crimp on an brass ferrule for air hoses?
This is the die I would like to use if it would fit in my crimper...just can't find dimensional info on these dies.
If anyone has a Milton crimper with dies can you give me the measurements of the dies?
Unless a hex crimp would work but I'm thinking these dies work with the barbed fitting.
Last edited: