JHZR2
Staff member
Hi,
My girlfriend has an older 4runner. A few months back, the radiator went bad, and there were a bunch of other problems.
Twice now, there have been situations where, when going up very steep hills, where there is high load, all of a sudden the trans will stop transmitting power, a hissing sound will devellop, and ATF will being bubbling or seeping out past the seals of the transmission pan, onto the ground. When it cools down a bit, the transmission will work again fine.
The ATF is a light pink/brown murky color. This I suppose is indicative of water contamination, and what I believe is happening is that there is water in there, and when it gets hot enough, the water starts to boil, causing the internals of the trans to not work, and the vehicle to go nowhere.
There is no sign whatsoever of crossover of ATF into the radiator, which I would assume would also occur if coolant was getting into the ATF.
I plan to drain it from the plug, refill as best as I can, drive a bit. Drain again, drive some more, drain, drive, etc. This way the contaminants get slowly washed out (Ive read this is better for ATs). After cleaning it thuroughly this way, then drop the pan/filter and replace all the fluid I can.
Is this the best method? Is there anything else to check? It shifts fine and operates great until the hissing, etc starts. Unfortunately there is no fluid exchange device available, as my gf lives on an island...
Thanks,
JMH
My girlfriend has an older 4runner. A few months back, the radiator went bad, and there were a bunch of other problems.
Twice now, there have been situations where, when going up very steep hills, where there is high load, all of a sudden the trans will stop transmitting power, a hissing sound will devellop, and ATF will being bubbling or seeping out past the seals of the transmission pan, onto the ground. When it cools down a bit, the transmission will work again fine.
The ATF is a light pink/brown murky color. This I suppose is indicative of water contamination, and what I believe is happening is that there is water in there, and when it gets hot enough, the water starts to boil, causing the internals of the trans to not work, and the vehicle to go nowhere.
There is no sign whatsoever of crossover of ATF into the radiator, which I would assume would also occur if coolant was getting into the ATF.
I plan to drain it from the plug, refill as best as I can, drive a bit. Drain again, drive some more, drain, drive, etc. This way the contaminants get slowly washed out (Ive read this is better for ATs). After cleaning it thuroughly this way, then drop the pan/filter and replace all the fluid I can.
Is this the best method? Is there anything else to check? It shifts fine and operates great until the hissing, etc starts. Unfortunately there is no fluid exchange device available, as my gf lives on an island...
Thanks,
JMH