Amsoil Power Foam ...

[Ndx]

Hey Guys,

I have can of Amsoil Power Foam...
I wonder if I should use it in my 2004 Mazda 3...
Car has around 120000Km on it ...

How to use it ? I have really no clue ... Where I should spray this in ...

Engine is good condition .. Does not take any oil ...
I used Redline Cleaner before ... Always Top Tire Gas

 

[Pablo]

Power Foam

Quote:
DIRECTIONS
Run engine to normal operating temperature and remove air cleaner assembly. While engine is running, spray entire can of foam directly into intake. Turn off engine and allow to sit for 5-10 minutes. Restart engine and drive to blow out deposits.

RECOMMENDATIONS
Avoid contact with hoses. To prevent the dissolving of paint, do not overspray. AMSOIL Power Foam is not recommended for use in diesel engines.


You can also use a partial can and repeat a few times

 

[chevrofreak]

I like to open the throttle butterfly and fill the entire intake manifold with the foam, them bump the engine over (without starting it) to suck it into the cylinders. I repeat until the can is gone.

 

[jorton]

Gumout Intake Manifold Cleaner spray has detailed instructions on the can and you can use those instructions for the Powerfoam.

 

[VNTS]

Take the TB off, pull the IAC and TPS and use the PF to clean the TB. THis does much better job and I can do it on any of my cars in 10 minutes. Spraying down the TB does OK but does not clean the passageways on IAC motor as well.