1995 4l60e rebuild tips needed

[Vger]

Clinebarger ??

 

[Vger]

Clinebarger is waiting for me to say I made a mistake,LOL-- I did ,I have so many parts that I overlooked the pack of .106 steels for the 3-4 and used stock ones --Tear back down tomorrow.

 

[clinebarger]

.030" is about loose as I would run a 3-4 clutch, Prefer .025".......I have no way to know when you post to this thread other than stumbling across it.

 

[Vger]

Installing Sonnax servo pin today. Sonnax says .075-.125--Clinebarger says .040. With everything assembled seals ,snap ring etc. and with my dial indicator I am reading .040 pushing in manually as far as physically possible--Are we good Sir?? BTW---I can turn the output shaft and see the drum rolling in the band but it is rubbing on the band slightly.You can hear it

 

[clinebarger]

If you can turn the output both directions, Plenty of clearance! I know it seems tight, But I've done it on thousands of 4L60E's & so has many other builders.