What are you working on today?

FIL welded the frame of my RV gates. He used to be a career welder. For today’s project, he wanted to stick weld, so I picked up a Titanium Stick 225 from HF for him to use.

He was pretty happy with its performance on 240V with ~85A output. We used 3/32” E6013. The frame is about 3mm thick.

I have no idea what I’m looking at - how does this look? Paging @D60

Before:
View attachment 345402

After:
View attachment 345403

View attachment 345404

View attachment 345405

View attachment 345406
That's pretty £ugly but I'm sure it's plenty strong. Stick welding 3mm is kinda brave as that's relatively thin for the process.
 
I just slapped a new starter on the old Chevy Express, since the old one was starting to get flaky. I would have probably rebuilt it if I had the parts, but it has to be back in service at 5 AM tomorrow. Battery and cables looked sharp so I’m sure that was it. It was pretty rough inside when I popped it open.

Of course while I was under there I noticed a small trail of coolant on the oil pan. Looks like the stupid NAPA water pump I put in a couple years ago is starting to leak from the weep hole. I’ve got an AC Delco on the way, hopefully it holds up better than the NAPA. I gotta say, the NAPA unit was terrible looking with some of the worst casting I’ve ever seen, but I needed it right now! so it went in anyway.
 
2013 Express:
-returned to have the MOVE bumper bolted up which I finally finished weldingView attachment 339658View attachment 339659
He'll have it powdercoated
Quoting myself, he got this powdercoated
image000001(3).webp
 
Neighbor that usually works on 🏍️ commissioned me to look at the car

It's a '23 CX-30, with the 2.5 NA/24k on it
Factory cabin filter 🤮
He smokes, that probably didn't help either
1000021907.webp

Some dark bulk nonsense and a jobber filter, plus the smushed OG crush washer came off
Wix 57002 and some Castrol Edge EP 0w20 went in
Check engine light was on, as were a few other dash emojis
I believe these stickers represent OCI #1 & 2, me being #3
I'm sorry, but that's just not enough IMO

My immortal statement rings true yet again
"Thank God it's a lease" 🙄
1000021904.webp

And these new cars keep receipts, they aren't afraid to snitch
Once he got the oil level low message, he stopped driving it 🫣
1000021912.webp

Definitely drove better after an OCI, and the A/C no longer feels like an asthmatic breathing through a straw
I fixed the oil level, that P2610 can be set by a poor start/weak crank (due to the bad battery)
It needs a battery badly, it just barely fires up
And there's a TSB/software update for the "In Vehicle Network Malfunction"
Because working on cars now is just a series of software updates 😒


If he still has it, it'll be back in 6m/5k, that's my default interval
If he doesn't, then it'll make a fine off lease Mazda CPO used vehicle in the tri state area 👀
/s
 
Back
Top Bottom