The new water heater I bought wants a 6” minimum heat trap for the cold water supply located at the bottom of the unit as shown from the instruction manual.
My existing line runs on the ceiling so I was just hoping to 90* down and then 90* back into the heater like my work of art shows. This would service the same purpose correct?
I just take this to mean they don’t want the cold water supply line going straight into the unit.
My existing line runs on the ceiling so I was just hoping to 90* down and then 90* back into the heater like my work of art shows. This would service the same purpose correct?
I just take this to mean they don’t want the cold water supply line going straight into the unit.