Transmission auxiliary filter

[Gary Allan]

Finally found it.

* Base housing and element measures 7 1/2in. high, diameter measures 3 5/8in.
* 14 threads per inch
* Recommend change time is 50 hours on new systems or break in and every 250 hours there after.

It should be a typo. The replacement element for this filter/head combo is the 4021 ..which does work in WIX

4021 NORTHERN HYDRAULICS 51453

Part Number: 51453
UPC Number: 765809514539
Principal Application: Case Combines, Tractors; Ford, IHC & M-F Tractors
All Applications
Style: Spin-On Hydraulic Filter
Service: Hydraulic
Type: Full Flow
Media: Paper
Height: 5.157
Outer Diameter Top: 3.670
Outer Diameter Bottom: Closed
Thread Size: 1-12
By-Pass Valve Setting-PSI: 7-9
Beta Ratio: 2/20=24/44
Burst Pressure-PSI: 300
Max Flow Rate: 12-16 GPM
Nominal Micron Rating: 35

Gasket Diameters
Number O.D. I.D. Thk.
Attached 2.729 2.415 0.255

 

[rufushusky]

Originally Posted By: Gary Allan
Finally found it.

* Base housing and element measures 7 1/2in. high, diameter measures 3 5/8in.
* 14 threads per inch
* Recommend change time is 50 hours on new systems or break in and every 250 hours there after.

It should be a typo. The replacement element for this filter/head combo is the 4021 ..which does work in WIX

4021 NORTHERN HYDRAULICS 51453

Part Number: 51453
UPC Number: 765809514539
Principal Application: Case Combines, Tractors; Ford, IHC & M-F Tractors
All Applications
Style: Spin-On Hydraulic Filter
Service: Hydraulic
Type: Full Flow
Media: Paper
Height: 5.157
Outer Diameter Top: 3.670
Outer Diameter Bottom: Closed
Thread Size: 1-12
By-Pass Valve Setting-PSI: 7-9
Beta Ratio: 2/20=24/44
Burst Pressure-PSI: 300
Max Flow Rate: 12-16 GPM
Nominal Micron Rating: 35

Gasket Diameters
Number O.D. I.D. Thk.
Attached 2.729 2.415 0.255



Hmmn...maybe a typo by northern tool?

 

[Gary Allan]

yeah ..it's a 1-12 thread filter.

From what I can find on Donaldson, there is only one 14 thread, a 3/4-14.

Let's see if this works

 

[rufushusky]

One last question, what would be a good bypass valve setting for the set up? Or is the setting not as important as the fact there is a bypass?

 

[Gary Allan]

Anything 15-25 should work. I doubt it will ever be used unless there's some catastrophic failure that sends tons of filterable material down the line.

The line is so skinny ..moving so much fluid ...it would be pretty hard to restrict flow enough to produce the PSID required to open it. The needle it has to thread though (long hose) will trump the filter by a decent margin.

Now open the tap on to the ground, and without any back pressure, it might .. I don't even think that would do it.

 

[rufushusky]

Great. Gary Allan thanks a lot you have really been a huge help! I really appreciate it!

 

[Gary Allan]

Glad to be of assistance!