Tool Chest Troubles

Status
Not open for further replies.
Joined
Apr 7, 2008
Messages
1,956
Location
Vermont
The middle drawer in the top section of my Craftsman ball-bearing tool chest won't open. All the other drawers are fine but the middle one (third one down) appears to have been pushed in further than normal and is stuck. I can't see anything amiss from the drawers immediately above or below it.

I haven't resorted to a pry bar and I really don't want to go there. Any suggestions?

SAM_0399-XL.jpg
 
Yup. I should have looked a little closer before posted here.

There was a bent tang on the back wall near where the locking rod slides. Thanks for the quick feedback. I think that one of my sons had something to do with this but it's going to be tough trying to figure out which one!!
 
Originally Posted By: bigdreama
I think that one of my sons had something to do with this but it's going to be tough trying to figure out which one!!


Whoever's smugly spending lots more time on a BMX bike or whatever he fixed.
wink.gif


You could contrive a reason for each son to retrieve something from that drawer; whoever has that "aw, shoot" look on their face is the guilty party.
crackmeup2.gif
 
Status
Not open for further replies.
Back
Top