What type of Ford?
The last time I bought Motorcraft sensors from RockAuto, I could tell with certainty they were reboxed Schrader units
I just bought a Denso for a '23 Hyundai, it was the OE Continental sensor with the Hyundai/Kia logo scrubbed off
If you DIY the programming, just supply the 4 new sensors to your tire installer
BH SENS RDE023V43 @ $18.51
Or
SCHRADER 29020 @ $23.79
I've had good luck with both
You can have your own trigger tool for $8
https://a.co/d/01GHi0uK
Tire Pressure Sensor Training
NOTE: In the following procedure, TPM Activation Tool (204-363) must be used.
NOTE: The tire pressure sensor training procedure must be done on a single vehicle, in an area without Radio Frequency (RF) noise and at least 3 ft. (1 m) away from any other vehicle equipped with TPM system. RF noise is generated by electrical motor and appliance operation, cellular telephones and remote transmitters, power inverters and portable entertainment equipment.
NOTE: A new tire pressure sensor is shipped in an OFF mode (or battery saver mode), and must be turned ON before it can be trained. To turn the sensor on, inflate the tire to the recommended inflation pressure and wait at least 2 minutes, then continue with the sensor training procedure.
Turn ignition switch to OFF position, then press and release brake pedal.
Turn ignition switch from OFF position to the RUN position 3 times, ending in RUN position. Do not wait more than one minute between each key cycle.
Press and release the brake pedal.
Turn ignition switch to OFF position.
Turn ignition switch from OFF position to the RUN position 3 times, ending in RUN position. Do not wait more than one minute between each key cycle.
NOTE: The horn will sound once and the tire pressure warning light will flash if train mode has been entered successfully (if equipped, the message center displays "TRAIN LF TIRE").
Place TPM Activation Tool (204-363) on the left front tire sidewall at the tire valve stem. Press the test button on the Activation Tool. The horn will sound briefly to indicate that the tire pressure sensor has been recognized by the SJB.
NOTE: It may take up to 6 seconds to activate a tire pressure sensor. During this time, the activation tool must remain against the sidewall of the tire.
NOTE: If a sensor does not respond to the activation tool, attempt to activate the same sensor using activation tool. If the sensor still does not respond, move the vehicle to rotate the wheels at least 1/4 of a turn and attempt to activate the same sensor again.
NOTE: If the SJB does not recognize any one of the 4 tire pressure sensors during the 2 minute time limit for each sensor response, the horn will sound twice and the message center (if equipped) will display "TIRE NOT TRAINED REPEAT". The training procedure must be repeated from the beginning.
Within 2 minutes after the horn sounds, place the activation tool on the right front tire sidewall -180 degrees from the valve stem for strap and cradle type sensors or at the valve stem for valve stem-mounted sensors. Repeat procedure for right rear and left rear tires, in that order.
NOTE: On vehicles with Dual Rear Wheels, activate the inner wheel sensors first, then the outer sensors.
NOTE: Do not wait more than 2 minutes between training each sensor. If the wait time is more than 2 minutes the SJB will stop and the training procedure must be repeated from the beginning.
When the tire training procedure is complete, the message center (if equipped) will display "TIRE TRAINING COMPLETE". For vehicles not equipped with a message center, successful completion of the training procedure will be verified by turning the ignition switch to the OFF position without the horn sounding. If the horn sounds twice when ignition is turned off, the training procedure was not successful.
.
