So the power locks stopped responding again on my truck. I had posted before about discovering it had some janky wiring in the passenger door including 2 random relays that I replaced and the locks worked again. Well they stopped working again. I opened up the door panel again and spent a few hours trying to get to the bottom of this. I took the cluster surround off as well as the lower panel around the column and found a Viper alarm. The wiring was terrible to say the least. I liked on the passenger door there was the factory wiring tied to speaker wire with both wires in the same end of a butt connector. I used a DT connector on that, using my new crimping pliers for the first time. Going to take this slow, I am looking for a factory wiring diagram to make sure everything gets connected. I will probably use DT connectors since I have an assortment. Here is some of what I found.