Put a Borla catback on the 2024 Tahoe

[redhat]

Got Borla axle backs on both my Hondas, on this car added the RV6 mid pipe and my exhaust guy says the fitment of borla is hard to beat. Better steel than magna flow and louder.

That sounds really good. Love a J. Sad to see them no longer in an Accord. I always loved the 9th gen. I was so jealous of them when I had my 8th. Though I thought the 8th was great for the last true double wishbone suspension.

On my 8th gen K, I had an RV6 catless down pipe. RV6 makes some fine pieces. Gorgeous work they do.

Will the Bora last as long as the SS original muffler. Never replaced a muffler before it rusted out

I think it should. Borla uses some good SS. I have a Borla HD truck muffler on my 2005 Tahoe and after a winter it still looks like new.

 

[Revving2Redline]

They have a lifetime 1 million mile warranty if you fill out the paperwork that comes with it

 

[OVERKILL]

Great choice! We have Borla (S-Type) on both vehicles. On the SRT, it's got a bit of a bark on start-up but is quite quiet driving around until you punch it, then it does fun stuff, even crackles on coasting. Perfect balance of civility and intensity; a bit of Jekyll/Hyde personality.

On my wife's 1500, I think we should have gone with the Commuter, which is the S-type with an additional resonator (and we could convert it, the wife doesn't want to). The S-Type is LOUD and you have to drive it like there's an egg on the pedal to keep it at a reasonable level.

 

[Revving2Redline]

Borla exhaust cleans up nicely with a bit of spray wax on the outer shell. On the inside of the tip where there's more carbon buildup and all that I try to use a very fine steel wool and a little bit of elbow grease occasionally. I'd like to get in there with a drill and really cleaned it up but all it would do would be draw more attention to the local authorities. On the Accord Sport, the exhaust comes out the same place as the two from the factory. Every time I've been pulled over I just explained that I have a small pen hole leak in the pipe and that's what's causing it although we all know that's not entirely true! If you look closely on the 12:00 position you can see the word borla engraved into the tips. I guess if I wanted to quiet it down I could try for a resonated exhaust tips but that would ruin the point of having a borla exhaust

 

[scip5.3L]

Which Ebay seller was it?

 

[redhat]

Great choice! We have Borla (S-Type) on both vehicles. On the SRT, it's got a bit of a bark on start-up but is quite quiet driving around until you punch it, then it does fun stuff, even crackles on coasting. Perfect balance of civility and intensity; a bit of Jekyll/Hyde personality.

On my wife's 1500, I think we should have gone with the Commuter, which is the S-type with an additional resonator (and we could convert it, the wife doesn't want to). The S-Type is LOUD and you have to drive it like there's an egg on the pedal to keep it at a reasonable level.

awesome you have them on there. I am loving the sound. It’s quiet at idle once warmed up and mellow while cruising. When you get into it, it sounds awesome.

 

[redhat]

Which Ebay seller was it?

Cable Dahmer Chevrolet

 

[wemay]

Sounds great!

 

[Ronn]

Nice!
Have always been a fan of well thought out cat back set up. It’s important that it be mellow and growling without being obnoxious and intrusive.

 

[wtd]

Sounds good. I've had a Borla cat-back on my 1998 Chevy K1500 since 1999.

 

[PF52]

I've had a Borla on my Fiero since 2003; I was lucky to get it because they were discontinued soon afterward.

I liked it so well I got one for my WRX also.