Nepros Flex Head Rachet?

[JWC86]

I’m looking at getting a Nepros Flex Head. I will probably get a 1/4 to start and then a 3/8 if I like it.

My only experience with flex heads is locking Gearwrench 90t, non locking Gearwrench 120s and non locking tektons.

The Nepros does not have any detents to hold the head in place, looks like it uses spring loaded Teflon bushing of some sort. How well does it hold the head?

I have a few non flex head Snap On 80s and have a urge to add a couple nice flex heads to the ratchet drawer but would like some feedback first.

 

[Sam_Julier]

I prefer the detents in the Tekton Flex head ratchets. They really hold the head in place. I use these ratchets all the time.

3/8 Inch Drive x 12 Inch Flex Head Quick-Release Ratchet | TEKTON | SRH31112

3/8 inch drive x 12 inch flex head quick-release ratchet. 90-tooth, 4-degree swing. 180-degree, 9-position Flex Head. Sleek, comfortable handle. SRH31112.

www.tekton.com

 

[JWC86]

Guess I should update this thread.

I picked up some of the Nepros, really like them so far.

 

[JWC86]

I prefer the detents in the Tekton Flex head ratchets. They really hold the head in place. I use these ratchets all the time.

3/8 Inch Drive x 12 Inch Flex Head Quick-Release Ratchet | TEKTON | SRH31112

3/8 inch drive x 12 inch flex head quick-release ratchet. 90-tooth, 4-degree swing. 180-degree, 9-position Flex Head. Sleek, comfortable handle. SRH31112.

www.tekton.com

I have a set of the Tekton flex heads, I don’t like the detents but I guess that’s personal preference.

These are my “go to” ratchets.

 

[Sam_Julier]

I have a set of the Tekton flex heads, I don’t like the detents but I guess that’s personal preference.

These are my “go to” ratchets.

Nepros are insanely beautiful tools. I simply can’t justify the expense for my level of work.