You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
-
V
Looks like I have bowl orientation off by 180 degrees. How critical is that? I wonder if that will hamper the high speed under load...
-
V
Opened it again and put the gasket back. Also adjusted the orientation of the bowl to match the float pin. Verified that gas does not...
-
V
aaarggggggg; I found the bowl gasket on the floor under the machine. For some odd reason, the diameter of it small and it is floating...
-
V
RE: " I wonder if the actual passageway is smaller than the hole?"
It only cost me $6.99 but yes, the passageway is tiny compared to the...
-
V
When I went to my appointment, they told me it will take 3 hours! I said I will wait and set up the laptop for work. About 15 minutes...
-
V
Without disconnecting the HV logic connector under the seat, 12V battery is always getting charged even after "turning off power" from...
-
V
not sure how to test that. I put the cigarette lighter voltmeter and the voltage showed 14.8
I disconnected the wall power, still...
-
V
my plug in voltmeter is in the other car; once I have that I will see if I can read the resting battery voltage to see if it is indeed...
-
V
Mine was replaced on April 29, 2024 and I got the warning today. The car has been on the charger for last 4 weeks and was not driven...
-
V
You think so? How do you know? Because you see gas splashing in the tank? Do you know where is the fuel pick up is located on that...
-
V
Buttoned it up and started. Now it idles at lowest settings! But I feel that idle speed is quite high but I am not going to open it...
-
V
Removed the pilot jet behind the rubber cap. It has big horizontal through hole. But the small one vertical does not come out all the...
-
V
Good news is that when sprayed the starting fluid in the throat, it fires up and runs for few seconds. That rules out all the major...
-
Loading…
-
Loading…