Roofless wrote the book on traveling tool storage but here is my travelling tool set up. I’m in Calgary, and will be spending a few days at U Wrench.
My travel setup
- Thread starter RooflessVW
- Start date
- Status
AutoMechanic
Site Donor 2026
U Wrench? Is that like one of those shops where you can rent a bay for a day and work on your car? If so that’s cool we need one of those in my area.
Yes, it’s $35 CDN per hour. They set your vehicle up on a hoist then allow you to operate the hoist while you work. These are very rare. We discussed this on a forum and most posters mentioned it wouldn’t work well in the USA due to liability laws.
AutoMechanic
Site Donor 2026
Oh ok interesting I didn’t know that.
Usually off-site AOG the aircraft is scrap and the occupants are dead.
Not really, no.
Nice setup. I’m assuming the box is too large to fit above the seats in an (unlikely) bad accident? Wouldn’t want a few hundred pounds of unsecured steel flopping around the cabin.
Yeah it's not going anywhere. A rollover would be fun to clean up though.
- Status
