This is the Dollar Tree buck a quart a couple of years back.
ALUMINUM............... 2
CHROMIUM............... 0
IRON................... 3
COPPER................. 3
LEAD................... 0
TIN.................... 3
MOLYBDENUM............. 33
NICKEL................. 0
MANGANESE.............. 0
SILVER................. 0
TITANIUM............... 0
POTASSIUM...............3
BORON...................117
SILICON..................17
SODIUM................... 9
CALCIUM.................. 1691
MAGNESIUM................. 7
PHOSPHORUS................691
ZINC......................852
BARIUM.................... 0
cSt Viscosity @ 100°C.....53.7
SUS Viscosity @ 210°F.....83.9
Flashpoint in °F........ 365
Fuel %.................. .5
Antifreeze %........... 0.0
Water % ............... 0.0
Insolubles %........... .3
TBN.................... 2.5
Blackstone's comments: You extended your oil use to 3,000 miles this time and there were only slight increase in copper.
However, all of the wear metals still read at or very close to the universal averages (which are based on a
4,900-mile oil run), so your Tacoma is doing quite well in comparison. The 0.5% fuel didn’t hurt anything.
The TBN read 2.5, showing plenty of active additive left in the oil. The oil's viscosity was just a bit low for a
10W/30 but not enough to cause any harm to the engine. Nice wearing Toyota at 42,598 total miles! Try
5,000 miles for your next oil change.
The truck is used about 90% back and forth to work which is about 9 miles one way and sometimes 3-4 mile drive to lunch. Not much of warmup, pretty much start up and drive with the A/C running. I thought the flash point would be higher for a semi synthetic oil. I still have about 50 quarts of this and will use it until gone, but will run it to 4000 miles.
ALUMINUM............... 2
CHROMIUM............... 0
IRON................... 3
COPPER................. 3
LEAD................... 0
TIN.................... 3
MOLYBDENUM............. 33
NICKEL................. 0
MANGANESE.............. 0
SILVER................. 0
TITANIUM............... 0
POTASSIUM...............3
BORON...................117
SILICON..................17
SODIUM................... 9
CALCIUM.................. 1691
MAGNESIUM................. 7
PHOSPHORUS................691
ZINC......................852
BARIUM.................... 0
cSt Viscosity @ 100°C.....53.7
SUS Viscosity @ 210°F.....83.9
Flashpoint in °F........ 365
Fuel %.................. .5
Antifreeze %........... 0.0
Water % ............... 0.0
Insolubles %........... .3
TBN.................... 2.5
Blackstone's comments: You extended your oil use to 3,000 miles this time and there were only slight increase in copper.
However, all of the wear metals still read at or very close to the universal averages (which are based on a
4,900-mile oil run), so your Tacoma is doing quite well in comparison. The 0.5% fuel didn’t hurt anything.
The TBN read 2.5, showing plenty of active additive left in the oil. The oil's viscosity was just a bit low for a
10W/30 but not enough to cause any harm to the engine. Nice wearing Toyota at 42,598 total miles! Try
5,000 miles for your next oil change.
The truck is used about 90% back and forth to work which is about 9 miles one way and sometimes 3-4 mile drive to lunch. Not much of warmup, pretty much start up and drive with the A/C running. I thought the flash point would be higher for a semi synthetic oil. I still have about 50 quarts of this and will use it until gone, but will run it to 4000 miles.
