So there was only once source of information that I could find my googling as far as the capacity of my diff. The source said that the rear diff held .7 quarts of fluid. This didn't seem right but I can't be sure since the Factory Service Manual says nothing about it. So I did the next best thing in my mind. There is only one drain/fill/inspection plug on the rear of the diff. I filled the diff with fluid until it poured out of the fill hole.
Unfortunately, I only had 2 quarts of Redline 75w-90 which I thought would be enough for the job. I ended up adding about .5 quarts of Redline MTL I had laying around which is 70-80 GL4.
So I guess 20% of the fill is Redline MTL. Do you think I will be ok?
Do I need more additives? I am not too woried about the weight but maybe I should be.
The diff is non lsd. Chrysler spec is 85w-90 for the rear diff but everyone else says it is 80w-90.
I have some mopar LSD additive laying around but not sure if that will help.
Is this mix ok, or did I take it too far?
Thank you
Unfortunately, I only had 2 quarts of Redline 75w-90 which I thought would be enough for the job. I ended up adding about .5 quarts of Redline MTL I had laying around which is 70-80 GL4.
So I guess 20% of the fill is Redline MTL. Do you think I will be ok?
Do I need more additives? I am not too woried about the weight but maybe I should be.
The diff is non lsd. Chrysler spec is 85w-90 for the rear diff but everyone else says it is 80w-90.
I have some mopar LSD additive laying around but not sure if that will help.
Is this mix ok, or did I take it too far?
Thank you
Last edited: