Search results

It will read my VIN and hook up properly. Just won't read codes or erase codes.

I guess I need a code first..

I'm on it...

Both

On my '98 Lexus LS400, I am getting 2 codes showing on my dash. One is the VSC red light. However, when I use my Blue Driver code reader to look up the codes, nothing shows up. Then I try to erase them and the Blue Driver can't erase them. I have to unhook my battery to get rid of the codes...

Found it! It was the black hinge over the big white connecter under the seat. Even though the connector was connected, I had to push this black lever over the top of the white connector. It was like this black plastic hinged arm that had to flip over the connector. Apparently since I had...

I moved my driver's seat up as far forward as it would go. I was fiddling around and left it like that overnight. Went out today to put the cleaned mats back in and the seat won't budge. Up, down, backwards, tilt, etc. The steering wheel will telescope and tilt. Any ideas? I just had my...

I did find that. Lol

I found where they go. I'll have to find a mechanical engineer to help me install them..LOL

I'll head out and start looking specifically at the rails.

Front or back?

I had a guy redo the driver's seat in my '98 LS400. When I got the car back, these 2 black pieces were in the rear floor board. I asked the leather guy what they went to. He said he had no idea. They were under the seat when he removed it. He said he searched all over the seat and could not...

Looks cool. But the only thing I need is something to check my ATF temp every 30-50K when I do my D&F’s on my transmissions.

I knew how to enter those 4 different codes. I knew how to check firmware. What was throwing me off was I saw on their website I needed firmware update 4.22 AND I had forgotten how long it takes to start "communicating". It must take a minute or so before it connects with the car. I ASSUMED it...

Yes

Well, it just got better. I called ScanGauge and talked to Orlando. What a nice guy. He walked through everything. Took his time with me going from garage to computer to garage..... My gauge is up to date. I have version 4.52 No firmware update is required. He helped me find all the...

Thank y’all. My issue is I just finished my 3rd drain and fill. Removed 3.5 qts cold fluid every time. Since I’m up to about 90% new fluid I’m done. I added an extra 1/2 qt of fluid this time and ASSUMED my Scan Gauge would work. I’ll check out the YouTube when I get home. Worse case is...

All I’m doing is changing the ATF. Need to get to 104 to check fluid level. Not doing any daily monitoring.

I have an old Scan Gauge ll I used on my older Toyotas and Lexus. I’m trying to check the ATF temp in my “new” ‘19 ES350. I had some difficulty this morning and did a little googling. It appears I may need firmware 4.22 in order to check the fluid temp in the ‘19. Can any of you shed some...

That explains my different temps. Some were quoting minimum and some in the middle of the range. That’s good to know. Thanks!