Search results

Looks almost like a Purolator Boss, comments say it's made in China?

Changed the tp roll today after 6 months, 1,000 Km's on this roll, did a lot of local short trips this past winter, in the past have gone 4,000 km's mostly highway, that seems to be the sweet spot, I think anyway. :)

I was searching ebay and got an offer on this, so the seller shouldn't mind if I lift the pictures, part number 13-00100, when you google search that number it does not come up at all, If I had to guess, it is is a new product.

Found a thin N50 magnet on ebay, 4mm thick, 40mm x 24mm, .160" thick 1.6" x 1" , it has about 2mm clearance with the Derale filter adapter, should be a good setup on the next auto trans project.

I've been reading all the Fram threads with the oil leak path at the leaf spring interface, I bought a few (6) off Amazon, as $4.38 cdn this is about half price of what Cambodian Tire sells them for, I think thats around $2.50 usd or close to it! I was wondering if they were all junk, this one...

Tp change, just a few hundred miles on a rebuild, 6 quarts of 10w30 Brad Penn #1, don't see the break in particles that the Wix 51515 had before, Wix replaced with an old school Fram HP1, return drains to pan and a needle valve on the inlet, engine oil pressure 45 at idle, 10 in the can, 75 at...

72' mustang 351c, I changed out my first roll after about 20 hours of run time, I hooked it up to the TV pressure test port and the return is to the dipstick tube, needle valve is on the inlet, it took a lot of fiddling with adjustments to end up at 3/4 of a quart per minute at cruise rpm, this...

So I collected a few nos decals off ebay, here's a couple I've done.

Seeing the Frantz was cooler to the touch in cold weather I picked up some 6 inch pipe insulation, with scissors and clear packing tape I made this cover, insulation factor is R-4.3

I found some good pictures of a 01-jr, I think they dropped production twenty years ago, one of Ralph Woods favorite little filters, he was a dealer for Gulf Coast back then, these filters a very elusive to find, you'll find a Motor Guard M100 before one of these it seems.

Here is my Jackmaster bench set up using a 1/2 reversible drill driving a Top 11-A cycloid oil pump, plastic tank is a cheap kerosene heater fuel tank. Spinning the drill at 650 rpm (according to Makita) it pushed room temperature 5w20 @25 psi at 3/4 of a litre per minute. Originally I built...