Recent content by Kaie

I personally did the same all the way around on my MDX. In fact what was factory in the back was too dark [legally] for the front but i went with it anyways to keep the uniform look.

Originally Posted By: Indydriver Which Chevron? If they are using Chevron Supreme, relax, this is a high quality, Tier 1 conventional oil. Just service it accordingly. so.... i just looked up info on Cheveron Supreme... I'm impressed by what the BITOG crowd has to say. Originally Posted By...

Just curious to what you guys are using in your 07-2013 Acura MDXs.. I recently learned that both local dealers don't use OEM Honda/Acura oil. But instead contract with Chevron lube. I have 0 issues doing oil changes on my own. I've been going to the dealer assuming they used Honda/Acura oil...

Originally Posted By: Warstud Originally Posted By: SuperDave456 I don't think the ratio of coolant you have would effect your MPG at all. I would be surprised if a your water pump took that much torque from your engine. I've spoken with guys who live in North Dakota and run 100% coolant in...

BAM! i went out since its dark to see if i could see any electrical [censored] shorting out. Sure enough BRAND NEW plug wire cracked right before the plug boot.

OK... so i'll try to keep this informative but short. I have almost always had misfiring issues in REALLY wet road conditions or after i go through and automatic car wash. I changed the plugs, wires, cap many times and it never fixed it so i just thought it was how my [censored] was going to...

Originally Posted By: Junior96Stang Originally Posted By: demarpaint The LG product is good, Kreen is good. Or just run a qt of MMO in place of 1 qt of oil your next OCI and clean the engine using that. Run it for 3000-4000 miles and change to your favorite oil. But I thought additives where a...

oh yeah i knew that, i just needed it this weekend. I forgot that i was going to add MoS2 to my next oilchange. I also got NAPA to get some LubroMoly Engine Flush too.

i would personally use a *w40 in your 2.0 BTW what chain stores carry lubro moly? NAPA has the injector cleaners but thats about it. Apparently NAPA can order any LubroMoly product so i did that.

Originally Posted By: dishdude I vote for air trapped in the system, or a bad head gasket. Compression gases could be entering the cooling system causing the gauge to peg.

go catless. =P

I use my defrost.

how is your ingition coil setup? if they are individual per cylinder then its probably not that. If you have one then it could very well be that.

Ignition coil?

well.... with further thought..... It appears and sounds over kill, but to have 2 catch cans on my system. On my engine, the pcv hose comes from the block and goes to the pcv valve which sits on top of the crank case. The valve also has an outlet to the intake. So if i dont want that garbage...