So I just switched to Valvoline Maxlife Syn Blend due to consuming 1qt every 3k miles. I have previously tried Valvoline Restore and Protect with no reduction in oil consumption. The vehicle is a 2015 F150 5.0. If I keep my intervals to 3k-5k, is there any reason to step up to their Full Synthetic high mileage blend? I know their syn blend is quite stout, and am leaning towards thinking the Full Synthetic would be a waste. Thanks.
Valvoline Maxlife Syn Blend vs Maxlife Full Syn
- Thread starter brandon9715
- Start date
I’d use the full sun; but I have lots of Valvoline Extended Protection High Mileage 5w30
- Joined
- Aug 15, 2024
- Messages
- 609
no, the syn blend will handle that interval just fine.
The past 2 changes in my Honda, I've used Pennzoil Full Synthetic High Mileage. I don't pay super close attention to my consumption because I'll top off as soon as I'm a 1/2 qt low but like you, it's about 1 qt per 3000 and I generally change ever 5000. My consumption is definitely less with this than it is with regular Platinum or Platinum High Mileage.
I tried Valvoline Restore and Protect also but only for 1 OCI and then it was out of stock and I wasn't that committed. so I just went back to Pennzoil.
I tried Valvoline Restore and Protect also but only for 1 OCI and then it was out of stock and I wasn't that committed. so I just went back to Pennzoil.
Supertech high mileage synthetic should be a cheap alternative.
Was also debating that. About $0.40/qt cheaper than the Valvoline syn blend.
I ran this for years in My old 2005 Chevy 5.3. I sold it 1year ago with 248,000 mile on the odometer and it used no oil when I sold it. Use it with confidence.
- Joined
- Nov 20, 2013
- Messages
- 1,137
I've had good luck with SuperTech high mileage and the Valvoline Maxlife synthetic blend, Id just go with the cheaper one.
I was going to put the Valvoline Syn Blend HM in my daughter's 08 Civic. It was $20/jug at WM. I flipped a coin and got ST Adv Full Synthetic HM instead for the same price. Any real-world different between using either of these? I highly doubt it.
That’s my thought now too. The ST high mileage Full Synthetic is a few bucks cheaper at my local Walmart, so I think I will use that going forward.
Carlostrece
$100 Site Donor 2025
I used the Valvoline Maxlife Synthetic for many years in my 97 Buick Park Ave that has 105K miles on it. I'm sure it was good oil for lubricating, but it leaked past my valve cover gasket and possibly also from a seal. It was a minor leak(s) that lost about ½ quart every 800 miles.
It wasn't a big deal mechanically, but it was staining the concrete floor of my parking spot in a shared condo garage. I put cardboard under my car to protect floor, but that was another eyesore. It was embarrasing because most of my neighbors parked all around me have newer cars. I like my old luxury car, but the oil leak(s) were bothering me.
Several months ago, I switched from Maxlife Synthetic to Maxlife Blend and the leak was greatly reduced. Instead of leaking a small puddle, it then leaked only a few drops. Much improvement from Blend.
Earlier this week my valve covers gaskets were replaced. Hopefully no more leaks. Time will tell. I still have Maxlife Blend in it.
If you want to use a Valvoline high mileage synthetic, then I suggest using
Valvoline Full Synthetic Extended Protection High Mileage (VFSEPHigh Mileage) because it's slightly thicker viscosity than Maxlife Synthetic. So (in theory) the VFSEPHigh Mileage should leak less than Maxlife Synthetic.
However, Maxlife Blend is the best of the 3 for not leaking because its viscosity at KV100 (100C or 210F) is same as VFSEPHigh Mileage, but the Blend is part (half?) conventional oil. Conventional oil leaks less because it's less slippery. i.e. - Conventional has less slipping past gaskets and seals.
Maxlife Blend has 2 advantages over Maxlife Syn in regard to less leaking. Blend is slightly higher viscosity and partially conventional oil.
Maxlife Blend has 1 advantages over VFSEPHigh Mileage in regard to less leaking. Blend is partially conventional oil.
VFSEPHigh Mileage has 1 advantage over Maxlife Syn, which is VFSEPHigh Mileage has slightly higher viscosity than Maxlife Syn.
There are other high mileage synthetic oils with higher viscosity than Maxlife Syn and VFSEPHigh Mileage, but I don't know how good they are because I don't know enough about them other than they have higher viscosity.
Castrol Edge High Mileage (synthetic) has higher viscosity than any Valvoline High Mileage product. Castrol Edge High Mileage is better than Castrol GTX High Mileage (Blend). In tests I've seen online, GTX flows very poorly at cold temps. Probably Edge flows better than GTX at cold temps.
Pennzoil Platinum High Mileage has a thicker viscosity than any Valvoline High Mileage oil. I don't know anything else about this oil.
Those two (Edge & Platinum High Mileage oils) are the only High Mileage Syn oils that have higher viscosity than VFSEPHigh Mileage (as far as I know).
The above are all higher viscosity than Maxlife Syn. In theory, higher viscosity oils would leak less.
Quaker State and Mobil 1 High Mileage oils are much thinner than all the above oils according to the published data/spec sheets of all oils mentioned.
I don't know anything about Amsoil or Supertec High Mileage oils. If anyone could post their specs for 5w20 the OP might appreciate that. I'd appreciate seeing their specs for 5w30.
Last edited:
Carlostrece
$100 Site Donor 2025
From published data sheets.
0w30
Valvoline Euro 65, 12.3
5w30
Valvoline Maxlife Syn 60, 10.7
Valvoline Maxlife Blend 65, 11
Valvoline Maxlife Plus (blend) 65, 11
Valvoline Extended Performance HM (syn) 64, 11
Pennzoil Platinum HM Syn 65.5, 11.4
Pennzoil High Mileage Syn 60, 10.5
Pennzoil High Mileage Blend 70, 11.7
Valvoline Daily Protection Blend 70, 10.5
Valvoline Euro 74, 12.4
Quaker State High Mileage Synthetic 10.8
Quaker State High Mileage Synthetic Blend 68.4, 11.1
Last edited:
Similar threads
