Threadlocking Plastic Threads

Joined
May 10, 2005
Messages
3,068
Location
Toronto, Canada
I am tired of this fitting coming loose when I am disconnecting the garden hose to my pressure washer. The male thread is plastic, and I learned a long time ago that Loctite weakens plastic.

The best I could come up with was applying a bit of masking tape to the male threads. It definitely made the fitting harder to thread on to the pressure washer.

Any suggestions?
IMG_1563.JPG
 
Teflon tape and tighten it better then you have been with the correct pliers. I see it has a hand hold, but maybe you have been too ginger with it. Dont use thread locker for a garden hose fitting. I've used blue on some 3d printed stuff and its holding fine.
 
I’d try the thick teflon tape for gas fittings. Yes it’s teflon. But the point is to tighten up the joint with some space filler and a bit more torque.
 
Back
Top Bottom