I just recently found this site and I find it most interesting, it is becoming a daily check for me. Already I have gotten answers for some of my questions. But, while going through the past posts and found some on piston slap that got me thinking.
The car in question is a 91 Honda Civic hatchback with the 1500 engine. 200,000 miles and it has always had Penzoil 5-30 changed every 5000 miles.
I have had it since new and for as long as I can remember it has a deep noise at a cold start-up. Depending on how cold it is the noise may last for a few seconds to maybe a minute and gets quieter until it is gone. With a little load on the engine, like letting out the clutch to start to move forward, it is a little louder.
I have always assumed it was a valve noise because it sounded to me like a collapsed lifter sounds or when you over tighten a lifter while adjusting one, but I am not sure anymore.
My question is does anyone know a way to identify my noise? How can I tell if it is valve noise or piston slap? Is there any test or technique to tell one from the other? I suppose it could also be rod noise but it hasn't gotten noticeably worse over the years.
Anyone with experence with this Honda motor already know what my noise is?
I assume it has solid lifters, is that a correct assumption? Valve adjustments seem to have no effect on the amount of noise.
Thanks.
Member number 998, nice number hun? Just made it in with 3 digits.
The car in question is a 91 Honda Civic hatchback with the 1500 engine. 200,000 miles and it has always had Penzoil 5-30 changed every 5000 miles.
I have had it since new and for as long as I can remember it has a deep noise at a cold start-up. Depending on how cold it is the noise may last for a few seconds to maybe a minute and gets quieter until it is gone. With a little load on the engine, like letting out the clutch to start to move forward, it is a little louder.
I have always assumed it was a valve noise because it sounded to me like a collapsed lifter sounds or when you over tighten a lifter while adjusting one, but I am not sure anymore.
My question is does anyone know a way to identify my noise? How can I tell if it is valve noise or piston slap? Is there any test or technique to tell one from the other? I suppose it could also be rod noise but it hasn't gotten noticeably worse over the years.
Anyone with experence with this Honda motor already know what my noise is?
I assume it has solid lifters, is that a correct assumption? Valve adjustments seem to have no effect on the amount of noise.
Thanks.
Member number 998, nice number hun? Just made it in with 3 digits.