Shield X - Flat shooter?

[ensoniqman]

After a tax return purchase of a new 9 M/P Sheild X this year, I'm finding it to be a flat shooter when it comes to center mass targets on the range at 10 yards (as compared to my PX4 and Walther).

Anyone else have this experience? I'm still getting use to the ergonomics with this model, but I'm liking it more and more.

 

[JohnnyG]

Kinda violates the laws of physics, doesn't it?
Probably due to muzzle jump. Or lack thereof.

 

[AZjeff]

Have never heard the term flat shooter applied to a handgun at close range. Could you explain further?

 

[ensoniqman]

Before the purchase, I read several reviews on other forums about it being a 'flat, low shooter' for this model. So when I tried it at the range after about 15 rounds, I noticed it was always low by about 4 inches. I assume that's what other reviews meant by flat shooter for this model.

I'm sure it's probably me with the trigger squeeze, maybe being a flat poly trigger....pulling too hard and down (or too gentle on the grip).

It's just when I use my other two, the aim seems more consistent.

 

[Astro14]

“Flat shooter” doesn’t violate any laws of physics, in fact, that feel is simple physics.

The higher the bore axis sits above your wrist, the more torque in the recoil impulse. A Sig P226 sits petty high above, as does my H&K USP.

If a gun is designed to sit low in your hands and puts the bore axis closer to your wrist, there is less torque.

Same force. Smaller lever arm moving the gun muzzle “up”. So, muzzle rise is reduced as the force goes more directly rearward, worrisome your hand less.

Pure physics.

Some new guns are much better than old ones about that bore height. They not only “feel” better - they are better.

 

[BISCUT]

NIB purchase or used? Check sight height fr/r. At 10 yards, even a weak 115gr target load is on the straighter side of fighting off gravity... Shoot it for fun at steel, 100 yards out, and you'll see the drop.

 

[ensoniqman]

Cool.

Thanks for the feedback and insight.

 

[danstraylee]

Are you used to the smaller framed pistols? If not, I recommend weighting the frame/rail with some tungsten putty or brass to achieve the desired muzzle rise (or not). Once you get it consistent then go to your local gunsmith and have it weighted permanently.

I personally do not like the smaller framed and shorter 9mm and larger shooters.

 

[Astro14]

I have Tungsten rods in my P365XL. The bore axis is low, that, and the added weight low in the frame, makes the pistol shoot as well as much bigger/ heavier guns.