Tomorrow I plan to replace a coolant bleeder screw on a 2006 Saturn Relay 3 with the 3.5L. (Same vehicle as a Chevy Uplander)
I will be using a GM# 10070107 as the replacement part.
Can I just take the old one off and put the new one in or do I need to drain some coolant out so the area can be dry before I put the new one on? This is for the one on the passenger side of the engine not the one on the thermostat housing.
Thanks
I will be using a GM# 10070107 as the replacement part.
Can I just take the old one off and put the new one in or do I need to drain some coolant out so the area can be dry before I put the new one on? This is for the one on the passenger side of the engine not the one on the thermostat housing.
Thanks