It's a stretch, but given the range of experience here maybe somebody knows.
I got some parts fabricated in 1/4" mild steel plate, and the shop burned the holes not accurately. They need to be 1" diameter, round, and all in the same relative location so the pins line up. As it is now, the holes are not round and only a little less than one inch. I would have been better off if they didn't put any holes in at all.
My experience with drill bits is if I try to run a 1" bit through these holes all I will do is shatter the outer cutting edges of the bit.
Thinking about a bridge plate reamer but wondering if anyone here has a better idea.
I got some parts fabricated in 1/4" mild steel plate, and the shop burned the holes not accurately. They need to be 1" diameter, round, and all in the same relative location so the pins line up. As it is now, the holes are not round and only a little less than one inch. I would have been better off if they didn't put any holes in at all.
My experience with drill bits is if I try to run a 1" bit through these holes all I will do is shatter the outer cutting edges of the bit.
Thinking about a bridge plate reamer but wondering if anyone here has a better idea.