radio control nitro fuel

Status
Not open for further replies.
Joined
Aug 24, 2008
Messages
3,681
Location
ks, wichita
i have two r/c trucks. both have a 3.3 cc two stroke, hp u/k but i think its about 2-3 hp, 35,000 rpm. normally i use nitro 20-30%, oil 10%, methanol rest. the trouble is i mix my own by volume. i was told that this way might not be accurate. and i understand why. what i need is an accurate way without buying a hydrometer. i think that useing weighing and volume together may work. thanks
 
I have been blending my own for quite sometime. First starting in airplanes and then moving to Cars. I have a Revo 3.3 and a 4.6 MGT and both run on my 30% actually much cooler then they did on sidewinder.

I have been usinf Klotz super techniplate. It has 20% bean oil castor.
 
TRX® 3.3 Racing Engine. ... Displacement: 0.20ci (3.3cc); Peak HP: 1.06hp @ 30900rpm; Peak Torque: 38.32 oz-in
 
Mine idle at around 1200. If they idle to fast the clutch will engage and the vehicle will move or lug and die. My big block idles a little higher
 
I have a mach 427 that can turn 43k rpm. Peak power is at 26k rpm though. I also have an Axial .28, not as much rpm but good power. You just gear differently for each engine. The 427 with stock gearing has a ton of power and plenty of top end speed.

Quote:
Team Losi 0.270 Mach 427 1.31 @ 26,750 rpm 53.80 oz-in @18,750 rpm 43,250 rpm Trinity Monster HP 30%


A whole bunch of engine dyno's for these little engines.


http://www.rc411.com/forum/showthread.php?t=2202
 
Last edited by a moderator:
can i ask a diff queston? ok here goes. could e-85 casoline be used in a scale nitro engine. my idea is this, gasoline and nitro are more alike than any other fuel. i think that gasoline will auto ignite like nitro/methanol. may need to and dilute the gasoline with methanol. what think?
 
Status
Not open for further replies.
Back
Top Bottom