So I'm trying to diagnose an issue with my brother's Winnebago Rialta which is built on 95 EuroVan chassis. It has the gas 2.5l 5 cylinder engine.
The condition is an intermittent crank, no start condition. It will sometimes start, but die soon after, especially if you try to drive it. I narrowed it down to fuel delivery. Spark is nice and hot and a little toot of ether make it fire right off until the either is consumed. After sitting a while it will start and idle again. Eventually.
When I got it, the battery was for knob dead, but it charged and the alternator is putting out a nice 14.4V.
First I tested the fuel pump relay because those are supposedly a common failure point, but it checks out good. When I apply 12v across the control pins, I get an audible click and 0 ohms across the power pins. It doesn't get hot while running, and I see 12v on the positive control pin with the key on.
Second, I pulled a fuel line off at the engine and rigged up a fuel pressure gauge. To my surprise, I'm seeing 86 psi at both fuel line at the regulators The spec that I found online says 36 or 40 psi.
Anybody have any experience with these? I'm starting to think it's not fuel delivery.
The condition is an intermittent crank, no start condition. It will sometimes start, but die soon after, especially if you try to drive it. I narrowed it down to fuel delivery. Spark is nice and hot and a little toot of ether make it fire right off until the either is consumed. After sitting a while it will start and idle again. Eventually.
When I got it, the battery was for knob dead, but it charged and the alternator is putting out a nice 14.4V.
First I tested the fuel pump relay because those are supposedly a common failure point, but it checks out good. When I apply 12v across the control pins, I get an audible click and 0 ohms across the power pins. It doesn't get hot while running, and I see 12v on the positive control pin with the key on.
Second, I pulled a fuel line off at the engine and rigged up a fuel pressure gauge. To my surprise, I'm seeing 86 psi at both fuel line at the regulators The spec that I found online says 36 or 40 psi.
Anybody have any experience with these? I'm starting to think it's not fuel delivery.